American Standard Saver Bath Walls Manual Do Utilizador

7 5 4 74 8 - 10 0 Rev. C

P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A S A m e r i c a I n c .
© A S A m e r i c a I n c . 2 0 1 2

NOTE: Take extra care in handling the front surfaces of the walls. Use only non-abrasive cloths to avoid scratching.

Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed
properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be
sure your installation conforms to local codes.

INSTALLATION INSTRUCTIONS

SAVER

™

BATH WALLS

MODEL: 2649BW

USE BATH WALL 2649BW WITH BATH TUB 2647.102 or 2647.202

REQUIRED TOOLS AND MATERIALS

BEFORE YOU BEGIN....

Local building codes vary by location. Observe all local plumbing and building codes.

Unpack your new shower walls and inspect them carefully for damage. Verify that the walls are the correct size for your
installation. Refer to American Standard roughing-in information for specific dimensions for each model.

Tape Measure

Caulking Gun

Level

Square

Pencil

Drill

Hole Saw or

Sabre Saw

TOOLS:

Acrylic/Latex or Acrylic/Silicone Sealant

Galvanized (or corrosion resistant) flat head screws 3/4" minimum length

2 x 4 lumber for additional wall studs as required

Tub Surround Adhesive

1 x 4’s if installing shower doors

MATERIALS:

PREPARATION:

Saver

™

bath tub walls are to be installed directly

over stud walls. Drywall is not required.

A) Remove dry wall surface and ensure that
alcove is plumb and square. (Illustration 1)

B) Identify your model number in the illustrations
which follow. Prepare studs as indicated.

Illustration 1

Each alcove
stud must
be plumb
and square.