Graham Field 7921R Manual Do Utilizador
GF0500057RevD10
1
7921R / 7931R: BATH SEAT
ASSEMBLY & OPERATION INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE
Note: The most current version of these instructions can be found online at
www.grahamfield.com
WARNING: Important! Read and understand these instructions before assembling or using the
Bath Seat. If you do not understand any part of these warnings, cautions or instructions, contact
a healthcare professional for direction in the use of this product. If the Bath Seat is not properly
assembled and adjusted, personal injury and damage to the Bath Seat could result.
a healthcare professional for direction in the use of this product. If the Bath Seat is not properly
assembled and adjusted, personal injury and damage to the Bath Seat could result.
WARNING: If components are damaged or missing, contact your dealer immediately. DO NOT use
substitute parts. Use only Lumex replacement parts. Non-Lumex replacement parts could cause
personal injury and damage to the Bath Seat.
personal injury and damage to the Bath Seat.
WARNING: This product has a weight limit of 350 lb.
WARNING: DO NOT use this product as a transfer bench or climbing device.
WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury caused by
WARNING: DO NOT use this product as a transfer bench or climbing device.
WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury caused by
improper assembly or use of this product.
ASSEMBLY
1. Remove the Bath Seat from the box and place it on a flat, dry surface.
1. Remove the Bath Seat from the box and place it on a flat, dry surface.
figure 1
figure 2
figure 3
figure 4
2. Locate the seat legs (see figure 1).
3. Locate the shortest screw knob and a curved washer (see figure 2).
4. Lay legs in “X” pattern over seat bottom (see figures 3 and 4).
3. Locate the shortest screw knob and a curved washer (see figure 2).
4. Lay legs in “X” pattern over seat bottom (see figures 3 and 4).
WARNING: Legs must be positioned exactly as shown in figure 3 for a safe and proper fit.
5. Install curved washer on screw knob. Fasten legs to seat by inserting screw knob through center leg
holes into seat and turning screw knob clockwise. Ensure screw knob is tight without overtightening.
WARNING: Ensure legs are securely installed and all hardware is tight before proceeding.
Note: If you are assembling 7921R (with backrest), proceed to step 6.
If you are assembling 7931R (without backrest), proceed to step 8b.
6. Locate backrest tubes, backrest, four
screw knobs, and four curved washers
(see figure 5).
(see figure 5).
7. See figure 6. Install curved washers on
screw knobs. Install backrest tubes on
backrest. Attach backrest tubes to back-
rest by inserting screw knobs through
backrest holes into backrest and turning
the screw knobs clockwise. Ensure screw
knobs are tight without overtightening.
backrest. Attach backrest tubes to back-
rest by inserting screw knobs through
backrest holes into backrest and turning
the screw knobs clockwise. Ensure screw
knobs are tight without overtightening.
Caution: Do not overtighten screw knobs.
figure 5 (7921R)
figure 6 (7921R)