Sunfire TGM-100 Manual Do Utilizador

User’s Manual

16. To prevent electric shock, do not use this polarized 

plug with an extension cord, receptacle or other outlet 

unless the blades can be fully inserted to prevent blade 

exposure. 

 

Pour préevenir les chocs électriques ne pas utiliser cette 

fiche polariseé avec un prolongateur, un prise de courant 

ou une autre sortie de courant, sauf si les lames peuvent 

être insérées à fond sans laisser aucune parIVe à décou-

vert.

17. Grounding or Polarization — Precautions should be 

taken so that the grounding or polarization means of the 

Component is not defeated.

This apparatus does not exceed the Class A/Class B (which-

ever is applicable) limits for radio noise emissions from digital 

apparatus as set out in the radio interference regulations of 

the Canadian Department of Communications.

ATTENTION — Le présent appareil numérique n'émet pas 

de bruits radioélectriques dépassant las limites applicables 

aux appareils numériques de class A/de class B (selon le 

cas) prescrites dans le règlement sur le brouillage radioé-

lectrique édicté par les ministere des communications du 

Canada.

WARNING – TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO 

NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF 

PLUG TO WIDE SLOT, FULLY INSERT. 
ATTENTION: POUR 

É

VITER LES CHOCS 

É

LECTRIQUES, INTRO- DU-

IRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRE-

SPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

EXAMPLE OF ANTENNA GROUNDING ACCORDING TO NATIONAL

ELECTRICAL CODE INSTRUCTIONS CONTAINED IN ARTICLE

810–“RADIO AND TELEVISION EQUIPMENT”

GROUND CLAMP

GROUNDING

CONDUCTORS

(NEC SECTION 810-21)

ANTENNA

LEAD IN WIRE

POWER SERVICE GROUNDING

ELECTRODE SYSTEM

(NEC ART 250, PART H)

SERVICE

ENTRANCE

EQUIPMENT

GROUND CLAMPS

GROUND CLAMPS

ANTENNA DISCHARGE UNIT

(NEC SECTION 810-20)

NEC NATIONAL ELECTRICAL CODE.

NOTE TO CATV INSTALLER

This reminder is to call the CATV system installer's attention to Article 820-40 of the NEC that provides guide-

lines for proper grounding and in particular, specifies that the cable ground shall be connected to the grounding

system of the building as close to the point of cable entry as practical. 

OUTSIDE ANTENNA GROUNDING

If an outside antenna is connected to the receiver, be sure the antenna system is grounded so as to provide

some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code,

ANSI/NFPA 70, provides information with regard to proper grounding of the lead-in wire to an antenna-discharge

unit, connection to grounding electrodes, and requirements for the grounding electrode. See Figure above.