Kenwood MGR-A7 Manual Do Utilizador

English

This unit uses a lithium ion rechargeable battery cell as the built-in battery. The lithium ion 

rechargeable battery is a recyclable resource. When disposing of the Transmitter, take out 

the built-in battery and bring it to your local recycling business.

•  Do not heat excessively the built-in battery, open it, modify it or throw it in fire or 

water.

Excessive heat generation, explosion or fire ignition may cause a fire.

•  Do not leave the built-in battery near fire or under direct sunlight.

A fire, explosion or excessive heat generation may result.

•  Attach insulating tape on the connectors of the built-in battery.

A fire or explosion may result if the battery electrodes are short-circuited.

•  Do not leave the built-in battery within the reach of children.

Injury or other accidents may result.

•  If the built-in battery fluid leaks and enters your eyes, immediately rinse your eyes 

with fresh water and call a doctor.

If the fluid is left in your eyes, an eye injury may result.

  Never attempt to open this unit besides when disposing of it. 

  For replacement of the built-in battery, contact your nearest Kenwood service agent.

  • Remove the built-in battery after having confirmed that it is completely discharged.

 

• Once the built-in battery is disconnected, do not attempt to reconnect it to the connector on 

the circuit board.

 

• Bring the removed built-in battery to a rechargeable battery recycling business as early as 

possible.

1 Open the SD card cover.

2 Remove the 2 screws from the panel 

using a precision Phillips screwdriver 
(+).

3 Slide and remove the front case of 

this unit. 

4 Disconnect the built-in battery 

connector and 3 microphone 
connectors. 

5 Using a precision screwdriver (+), 

remove the 3 screws and remove the 
circuit board. 

6 Using the precision screwdriver (+), 

remove 2 screws and remove the built-
in battery mount. 

7 Take out the built-in battery. 

8 Attach a piece of insulating tape on 

the connector at the end of the cable 
from the built-in battery, and put it in a 
plastic bag, etc.