Yamaha PJP-100UH Manual Do Utilizador
PREPARATION PROCEDURE
11
PRE
P
ARA
T
ION
English
Follow the procedure below to install this unit in the place of conference, such as a conference room.
■ Take the positions of the talkers in consideration
To assure the clear conversation by making the most of the effect of arrayed microphones and speakers, place this unit so
that the talkers sit at the area highlighted on the following figure.
that the talkers sit at the area highlighted on the following figure.
The microphones cannot pick up the audio clearly when the talker sits in one of the positions marked “x” in the figure above.
y
Depending on the using environment, you can configure the setting of the audio pickup area. Refer to “Selecting the audio pickup area
(microphone mode)” (page 16) for details.
(microphone mode)” (page 16) for details.
■ About installation environment
The speakers of this unit are attached in the downward orientation on the bottom panel. Place this unit horizontally on a
desktop without placing any object below this unit. In case you cannot place the unit stably because of the shape of the
desk or other reasons, attach the supplied pads (3 pieces) as illustrated.
desktop without placing any object below this unit. In case you cannot place the unit stably because of the shape of the
desk or other reasons, attach the supplied pads (3 pieces) as illustrated.
Step 3: Installing this unit in the conference room
Note
Front of this unit
Front of this unit
Side of
this unit
Side of
this unit
this unit
Display side
Back panel of this unit
1 pad
Concave part
Pad
Rubber cushion
Pad
Attach 1 pad at the center so
that the concave part is
covered.
that the concave part is
covered.
Attach 2 pads at the corner so that
the rubber cushions are covered.
the rubber cushions are covered.
2 pads
01EN_00_PJP-100UH_UCGB.book Page 11 Wednesday, August 23, 2006 1:49 PM