EAW NL8 Manual Do Utilizador

With the grille still removed, 
a.

Reposition the enclosure front down. 

b.

Remove the 18 hex head screws and flat 
washers that attach the two lids. 

c.

Lift the the two lids from the enclosure.
Retain the hardware and lids. 

d.  Remove all the polyfill fiber that surounds

the 10” and 15” drivers. Retain the polyfill.

e.

Disconnect the 2 electrical leads from both
drivers. 

f.

Remove the 8 socket head screws that hold
both drivers into the enclosure and lift the
drivers away. Do not retain hardware or 
drivers.

g.

Remove and discard the 8 input Phillips
head mounting screws and dangle the input to the side of the enclosure as shown. 

h.

Free the electrical leads that pass thru partitions inside the enclosure. 

i.

Remove and discard the 4 crossover mounting screws and lift the electrical assembly from the enclosure.

a.

Attach the new crossover as shown 
with the 4 supplied #8 x 1” long 
Phillips head screws.

b.

Insert the blue and black leads from 
the input board thru the partition 
into the 15” woofer chamber.

c.

Insert the red and black leads from 
the crossover board, thru the parti-
tion, down thru the rectangular hole 
into the HF chamber.

d.

Seal the hole in the partition with 
user supplied putty or silicone.

a.

Place the wooden aperture and new phase
plug into the mid chamber.

b.

Position the new 10” driver onto the phase 
plug.

c.

Insert the 4 supplied 4-1/2 lg screws, lock
washers and M6 flat washers thru the 
driver, phase plug and aperture into the 
threaded holes in the baffle and tighten. 

d.

Install the input with the 8 supplied #10
Phillips head screws.

e.

Connect the yellow and black leads from
the input board to the 10” mid driver. The 
black lead to the black terminal.

f.

Attach the new 15” woofer using 4 supplied
1/4-20 x 1-1/2 long screws.

g.

Connect the blue and black leads from
the input board to the 15” woofer. The black
lead to the black terminal.

h.

Restaple the polyfill into both chambers.