Phase Technology FP6030 Manual Do Utilizador

 

Technical Information for System Engineers

Technical data, EASE

™

 plots, SoundTubeSPEC

™

 software & product downloads available at www.soundtube.com

projected into the dome, SoundTube’s 
proprietary technology reflects sound 
waves from the upper registers of the 
frequency spectrum directly beneath 
the dome.

  SoundTube Entertainment is con-
sistently developing new technologies 
that enhance audio product perfor-
mance.  SoundTube Entertainment 
innovations are protected by multiple 
U.S. and international patents, which 
explicitly cover SoundTube dome, 
enclosure, mounting and dispersion 
technologies.  SoundTube Entertain-
ment actively defends it patents in 
order to protect SoundTube resellers 
and end-users.

Technical Data

chnical Data

  SoundTube Entertainment strives to 
provide complete and effective technical 
information and data to dealers, engi-
neers and designers.  All data are avail-
able from SoundTube Entertainment, or 
at www.soundtube.com.  

Technical data and downloads include:

EASE™ data – 3-D polar plots

Tech Sheets – Technical information and 
architectural specs for system engineers.

Da

Data Acquisition

ta Acquisition

  All performance data are acquired 
from SoundTube’s Technical Measure-
ment Center and always verified by 
independent sources.  For questions 
about specific testing procedures, con-
tact SoundTube Entertainment direct  
(techinfo@soundtube.com..)All data are 
analyzed using a variety of standard 
measurement techniques, including 
Measured Length Sequence (MLS) 
and Time Delay Spectrometry (TDS).  
Performance, development and data 
acquisition tolls include: Gold Line TEF 
20, CLIO, LMS, LEAP and proprietary 
modeling software. EASE™ data are 
acquired through an automated TEF 
20/Outline/EASE™ interface. 

Da

Data for Other SoundTube 

ta for Other SoundTube 

Products

Products

  Also available: Sales & installation 
information for all SoundTube speaker 
systems, including open-ceiling, in-
ceiling, surface-mount, in-ground and 
sound-focusing speakers.

Architectural Specifications

hitectural Specifications

  The loudspeaker shall consist of two 
25 mm (1.0 in) transducers with a voice 
coil diameter of 20.5 mm (0.81 in).  Sound 
waves from the transducers shall be 
reflected from a 781 mm (30.75 in) Dual-
Parabolic™ sound dome.

  Performance specifications of a typical 
unit shall be as follows: Useable frequency 
response shall extend from 104 Hz – 22 
kHz (-10 dB).  Measured sensitivity (2.83 
Volt input, 0.5 meter) shall be at least 80.5 
dB stereo (83.5 dB mono). The maximum 
continuous output at 0.5 meter shall be 
92.5 dB stereo or 95.5 dB mono. The loud-
speaker shall come with a CAT 5 plus  four 
16-gauge hardwire leads and be avail-
able in 8 Ohm impedance mode (4 Ohm 
if bridged/mono), or with an optional 
25/70.7/100 Volt transformer and accompa-
nying junction box.  For the 8 Ohm model, 
tap setting will be by hardwire lead.  For 
the transformer model, the transformer 
unit and 4-position tap switch will be sup-
plied in a junction box.  

  The dome shall be constructed of  
custom-molded PETG with a high-impact 
polystyrene driver enclosure.  The trans-