IBM 760C/CD (9546) Manual Do Utilizador
Undetermined Problems
You are here because the diagnostic tests did not identify
which adapter or device failed, installed devices are
incorrect, a short circuit is suspected, or the system is
inoperative. Follow the procedures below to isolate the
failing FRU (do not isolate nondefective FRUs).
which adapter or device failed, installed devices are
incorrect, a short circuit is suspected, or the system is
inoperative. Follow the procedures below to isolate the
failing FRU (do not isolate nondefective FRUs).
Verify that all attached devices are supported by the
computer.
computer.
Verify that the power supply being used at the time of the
failure is operating correctly. (See “Power Systems
Checkout” on page 349.)
failure is operating correctly. (See “Power Systems
Checkout” on page 349.)
1. Power-off the computer.
2. Check the cables, wires, and connectors for short
2. Check the cables, wires, and connectors for short
circuits and open circuits. Visually check them for
damage. If any problems are found, replace the
FRU.
damage. If any problems are found, replace the
FRU.
3. Remove or disconnect all of the following devices:
a. Non-IBM devices
b. Devices attached to the expansion bus
connector
c. Printer, mouse, and other external devices
d. Battery pack
e. Hard disk drive
f. Diskette drive/CD-ROM drive or the device
attached in the UltraBay.
g. DIMM
h. PC Cards
h. PC Cards
4. Power-on the computer.
5. Determine if the problem has changed.
6. If the problem does not occur again, reconnect the
5. Determine if the problem has changed.
6. If the problem does not occur again, reconnect the
removed devices one at a time until you find the
failing FRU.
failing FRU.
7. If the problem remains, replace the following FRUs
one at a time. Do not replace a nondefective FRU.
DC/DC card
Video card
Keyboard card
LCD assembly
System board
DSP card or audio (ESS) card
CPU card
ThinkPad 760 (9546, 9547)
371