Philips AJ260/79 Folheto

DC 7.5V

–  The weather forecast based on the 

atmospheric pressure may vary slightly from 

the actual weather situation.

The outdoor sensor is supplied to work with 

the main unit to measure and display the 

outdoor temperature.

1

  Place the sensor in a desired open area. 

The place must be within 50 meters away 

from the main unit. (Make sure that the 

sensor is loaded with 2 AA batteries.)

For the first time using the outdoor sensor 

• 

and the main unit, press RESET located 

on the sensor back, and RESET located 

in the battery compartment of the main 

unit. Then, the main unit will begin to 

receive transmission from the sensor.

To update the outdoor temperature 

• 

from the sensor any time, press and hold 

AUTO SCAN/DATE for 5 seconds.

–  Refer to the supplied User Manual for more 

information about the outdoor sensor.

1

  Connect the supplied mains adapter to the 

sets 7.5V DC jack and the plug into a wall 

outlet.

1

  Press and hold TIME SET or ALM1 / 

ALM2 until the time digits flash.

2

  Press and hold TUNING +/-  to adjust 

time.

3

  Press TIME SET or ALM1 / ALM2 to 

confirm.

4

  Repeat the steps 2-3 to complete all the 

other time items setting.

In standby mode, slide the RADIO/BUZ to 

select desired mode.

–  If you have selected RADIO, make sure 

you have properly tuned to a station before 

turning off the set.

Press 

• 

SLEEP/ALARM RESET.

Press 

• 

BRIGHTNESS CONTROL.

Press 

• 

ALM1 or ALM2.

1

  Press RADIO ON/OFF once to switch 

on the radio. 

2

  Press AUTO SCAN/DATE to program 

all available stations. 

3

  Press PRESET repeatedly until the desired 

preset station is displayed.

The unit can auto detect and measure 

atmospheric pressure changes to graphically 

display the weather forecast in the next 12 to 

24 hours, and current indoor temperature.

© 2010 Koninklijke Philips Electronics N.V.
All rights reserved.
AJ260_79_QSG_V1.0_1029

AJ260_QSG_79_wk1029.2.indd   2

2010-7-20   13:48:17