Technika SP-129I Manual Do Utilizador
6
REMOTE CONTROL
a
Standby/Snooze button 1# Volume up button
b
Time/Sleep button
1$
Memory button
c
Source button
1%
Volume down button
d
Play/Pause/Mono button 1^ Scan button
e
Search up button
1&
Menu button
f
Search down button
1*
Enter button
g
Stop button
1(
Right button
h
Playlist + button
2)
Repeat button
i
Up cursor button
2!
Previous/Alarm 2 button
1)
Left cursor button
2@
Next/Alarm 1 button
1!
Down cursor button
2#
EQ button
1@
Playlist - button
2$
Mute button
BEFORE FIRST USE
To prepare the remote control for first use, pull out the safety
strip to activate the battery.
To prepare the remote control for first use, pull out the safety
strip to activate the battery.
BATTERY DISPOSAL
Dispose of used batteries with regard to the recycling
regulations in your area. Do NOT short circuit batteries or
throw them into water, the general rubbish or in a fire.
Weak batteries can leak and damage the remote control.
Replace them in good time!
Dispose of used batteries with regard to the recycling
regulations in your area. Do NOT short circuit batteries or
throw them into water, the general rubbish or in a fire.
Weak batteries can leak and damage the remote control.
Replace them in good time!
REMOTE CONTROL BATTERIES
REPLACING THE BATTERY
When replacing the battery in the remote control, refer to the
diagram below.
1. Press the catch across.
2. While holding the catch, open the battery door.
When replacing the battery in the remote control, refer to the
diagram below.
1. Press the catch across.
2. While holding the catch, open the battery door.
3. Fit the battery observing polarity as shown. When
replacing the battery, use only the same CR2025 type
specified.
specified.
FM AERIAL
Before using your radio, unwrap and extend the aerial wire.
You may need to adjust the position of the aerial wire for best
reception.
CONNECTING POWER
Before using your radio, unwrap and extend the aerial wire.
You may need to adjust the position of the aerial wire for best
reception.
CONNECTING POWER
Check that the mains voltage marked on the rating plate
•
on the back panel is the same as the voltage in your
area.
Plug the AC power cord into the AC inlet
area.
Plug the AC power cord into the AC inlet
•
Plug the mains plug into the wall socket and switch the
•
mains power on.
POWER CONTROL
To turn the clock/radio on:
To turn the clock/radio on:
Press the
•
Standby button on the top panel or remote
control.
The display will light and the unit will begin to play.
To turn the clock/radio off:
To turn the clock/radio off:
Press the
•
Standby button on the top panel or remote
control.
The display will switch off and the Standby indicator will light.
GETTING STARTED
TIME DISPLAY AND LIGHT
To switch on the time display and light at any time when the
unit is set to Standby, press the SLEEP/TIME button on the
top panel or the SLEEP/TIME button on the remote control
briefly.
unit is set to Standby, press the SLEEP/TIME button on the
top panel or the SLEEP/TIME button on the remote control
briefly.