Ariston ASD70CX Manual Do Utilizador

1.

Plug the dryer into the electrical socket.

2.

Sort your laundry according to fabric type (

).

3.

Open the door and make sure the filter is clean 
and in place and that the water container is 
empty and in place (

).

4.

Load the machine and make sure items are not 
in the way of the door seal. Close the door.

5.

If the On/Off light is not lit: Press the ON/OFF button

6.

Press the Programme selection button that 
corresponds to the fabric type being dried by 
checking the Programmes table (

) 

as well as the indications for each type of fabric 
(

). 

7.

Choose Timed Drying or Dryness Levels option. 
- If Timed Drying press and release Timed button 
until the time required is displayed, or... 
- To change from default dryness setting press 
and release Dryness Levels button until required 
level is indicated.
!

See Programmes table, for more details.

8.

Set a delay time and other options if necessary.

9.

If you wish to select the buzzer sound, at the end 
of the programme, press the ALARM button      .

10. Press the START button      to begin. The display 

will  show the estimated time to end.
During the drying programme, you can check on 
your laundry and take out items that are dry 
while others continue drying. When you close 
the door again, press the START button in order 
to resume drying.

11. During the last few minutes of Drying 

Programmes, before the programme is 
completed, the final COOL TUMBLE phase  
is entered (fabrics are cooled), this phase should 
always be allowed to complete.

12. The buzzer (if Alarm Option was selected) will 

warn you when the programme is complete and 
the display shows          . 
Open the door, take the laundry out, clean the filter
and replace it. Empty the water container and 
replace it (

).

If the Post Care       option has been selected 
and you do not remove the laundry immediately, 
the dryer will tumble occasionally for 10 hours 
or until you open the door.

13. Unplug the dryer.

‘Easy Iron’ is a short 10 minute programme (8 minutes of heat followed by a 2 minute cool tumble period) which
fluffs the fibres of clothing that have been left in the same position/location for an extended period of time. The cycle
relaxes the fibres and makes them easier to iron and fold.
!

‘Easy Iron’ is 

and should not be used for wet articles of clothing.

For best results:

1.

Do not load more than the maximum capacity. These numbers refer to the dry weight:

Cotton and Cotton mixtures

2.5kg

Synthetics

2kg

Denim

2kg

2.

Unload the dryer immediately after the end of the programme, hang, fold or iron the articles and put 
them away in the closet. Should this not be possible repeat the programme.

The ‘Easy Iron’ effect varies from one fabric to the next. It works well on traditional fabrics like Cotton or Cotton mix,
and less well on acrylic fibres and on materials such as Tencel®.

●

This is a programme for tumble dryer safe garments marked with the symbol       .

●

It can be used for load sizes up to 1kg (approximately 3 sweaters).

●

We recommend that garments are turned inside out before drying.

●

This programme will take about 20 to 40 minutes, but may take longer depending on the size and density of 
the load and the spin speed used in your washer.

●

Loads dried using this programme are usually ready to wear, but on some heavier garments the edges may 
be slightly damp.  Allow these to dry naturally as over-drying could damage garments.  

!

Unlike other materials, the mechanism of wool shrinkage is irreversible; i.e. it will not stretch back to original

size and shape.
!

This programme is not suitable for Acrylic garments.