Whirlpool W10423119A Manual Do Utilizador

Using a Torx

®†

 T25 screwdriver, remove the 2 screws securing 

the  door strike to the door frame of the dryer. Rotate the 

strike 180° and attach to the opposite side of dryer door 

frame, as shown.

Position the door with the inside of the door facing up. Using  

a Phillips screwdriver, remove the 10 screws securing the inner 

door to the outer door. Lift off the inner door and set aside. 

ImPoRTAnT: If the protective film has not yet been removed 

from the dryer, peel the film from the dryer door before 

proceeding.

Using a Torx

® †

 T25 screwdriver, remove the 4 screws securing 

the door hinge to the dryer and lift up and out to remove the 

door. Place the door on a soft towel or other non-scratch 

surface. Reinstall the 4 screws in the holes. 

Using a Phillips screwdriver, remove the 2 screws from the outer 

window retainer and rotate the outer window assembly clockwise 

until the square notches line up with the 4 tabs on the trim ring 

indicated with arrows in the figure A above. Then lift out the outer 

window and retainer up and off the trim ring and set aside (B).

A

B

† ® TORX is a registered trademark of Saturn Fasteners, Inc.