Whirlpool W10443041B Manual Do Utilizador

C

E

B

F

A

Connect ground wire (green or bare) (F) of direct wire cable 

to external ground conductor screw (A). Tighten screw.

Place hooked ends of remaining direct wire cable wires under 

outer terminal block screws (hooks facing right). Squeeze 

hooked ends together and tighten screws. Finally, reinsert tab 

of terminal block cover into slot of dryer rear panel. Secure  

cover with hold-down screw. Now, go to “Venting Requirements.” 

Connect neutral ground wire (E) and place hooked end (hook  

facing right) of neutral wire (white or center wire) (C) of direct 

wire cable under center screw of terminal block (B). Squeeze 

hooked ends together and tighten screw.

B

Use where local codes permit connecting  

cabinet-ground conductor to neutral wire. 

Remove center terminal block screw (B).

Direct wire cable must have 5 ft. (1.52 m) of extra length so 

dryer may be moved if needed.

Strip 3

1

/

2

" (89 mm) of outer covering from end of cable. Strip 

insulation back 1" (25 mm). If using 3-wire cable with ground 

wire, cut bare wire even with outer covering. Shape wire ends 

into hooks. 

To connect wires to terminal block, place hooked end of 

wire under terminal block screw, facing to the right, squeeze 

hooked end together and tighten screw.