Whirlpool W10563341A Manual Do Utilizador

IMPORTANT: 

A 4-wire connection is required for mobile homes 

and where local codes do not permit 3-wire connections. 

E

A

B

Remove center terminal block screw (B). Remove neutral 

ground wire (E) from external ground conductor screw (A).

Direct wire cable must have 5 ft. (1.52 m) of extra length so dryer 

may be moved if needed.

Strip 5" (127 mm) of outer covering from end of cable, leaving 

bare ground wire at 5" (127 mm). Cut 1

1

/

2

" (38 mm) from 

remaining 3 wires. Strip insulation back 1" (25 mm). Shape ends 

of wires into hooks.

IMPORTANT: Use where local codes permit connecting  

cabinet-ground conductor to neutral wire. 

A

F

Connect ground wire (green or bare) (F) of direct wire cable 

to external ground conductor screw (A). Tighten screw.

Place hooked ends of remaining direct wire cable wires  

under outer terminal block screws (hooks facing right). 

Squeeze hooked ends together and tighten screws. Finally, 

reinsert tab of terminal block cover into slot of dryer rear 

panel. Secure cover with hold-down screw. Now, go to 

Venting Requirements. 

B

E

C

Connect neutral ground wire (E) and place  

hooked end (hook facing right) of neutral wire (white or center 

wire) (C) of direct wire cable under center screw of terminal 

block (B). Squeeze hooked ends together and tighten screw.

Direct wire cable must have 5 ft. (1.52 m) of extra length so 

dryer may be moved if needed.

Strip 3

1

/

2

" (89 mm) of outer covering from end of cable. Strip 

insulation back 1" (25 mm). If using 3-wire cable with ground 

wire, cut bare wire even with outer covering. Shape wire ends 

into hooks.