Whirlpool W10398830A Guia Do Utilizador

Press to turn the dryer on and off. Press again  

to stop/cancel a cycle at any time.  

Use your dryer’s cycle control knob to select available 

cycles on your dryer. Turn the knob to select a cycle 

for your laundry load. See “Cycle Guide” for detailed 

descriptions of cycles.

When you select a cycle, its default settings will light  

up and the Estimated Time Remaining (for Automatic 

Cycles) or actual time remaining (for Manual Cycles)  

will be displayed. 

This will indicate that the selected cycle has ended  

and the load may be removed from the dryer. If the 

Wrinkle Shield option has been selected, the dryer  

may continue to tumble the load, even if the DONE 

indicator is lit. 

At the beginning of an Automatic Cycle, the sensing  

light illuminates as the dryer senses the load size and  

adjusts for the appropriate dry time for that load. This  

indicator will not light during Timed Cycles or with  

options such as Wrinkle Shield™.

Your dryer is specially designed to conserve energy. Each 

cycle, along with selected options, will result in different 

energy usage, which will be displayed on the Eco Monitor 

bar, allowing you to choose the best energy usage for each 

load.

Press to start a cycle, or press once while a cycle is in 

process to pause it.

Use these buttons to select available options for your dryer. 

Not all cycles and options are available on all models.

Press to activate Eco Boost option on select Automatic 

cycles. The Eco Boost option allows you to increase 

your energy savings with minimal impact on cycle dry 

times.
NOTE: Selecting the Eco Boost option adds 5 minutes 

to the default cycle time.

Not all features and cycles are available on all models.

Press to add the Static Reduce option to select cycles 

(see Cycle Guide). The dryer will automatically tumble 

and spray to introduce a small amount of moisture  

into the load to help reduce static. This option adds  

approximately 8 minutes to the total cycle time. 
Damp Dry Signal 

When selected, a signal will sound during the drying  

cycle when the load is damp but not completely dry. 

This will allow you to take clothes out of the load that 

do not need to dry completely. This option is available 

on Heavy Duty, Normal, Sheets, Active Wear, Towels, 

Casual, Jeans, and Delicate cycles. It is a default  

option for the Bulky Items cycle.
Wrinkle Shield

If you will be unable to remove a load immediately, 

press WRINKLE SHIELD

™

 to add up to 140 minutes of 

periodic tumbling to help reduce wrinkling. On models 

with Wrinkle Shield

™

 with Steam, a short steam cycle  

is added after 60 minutes to help smooth out wrinkles. 
Cycle Signal 

Use this button to turn the signal indicating the end of 

a drying cycle on or off, or to adjust the volume of the 

signal.  

The Check Vent indicator light will come on if a  

blocked vent or low airflow issue is detected. For  

more information on maintaining good airflow, see 

“Check Your Vent System for Good Airflow”.

Use these buttons to select available modifiers for your 

cycles. Not all cycles and modifiers are available on all 

models.

Dryness Level
You may adjust the Dryness Level on Automatic 

Cycles, if desired. 
NOTE: The Dryness Level modifier is for use with  

Automatic Cycles only. Not available on the Sanitize 

cycle. 

When using Manual Cycles only, you may select  

a dry temperature based on the type of load you  

are drying. Use the warmest setting safe for the 

garments in the load. Follow garment label instructions.
NOTE: Automatic Cycles use a preset temperature  

that is not adjustable.