JVC GR-D790U Manual Do Utilizador
EN
37
FEATURES FOR RECORDING
MasterPage: Start_Right
ADV
ANCED FEA
TURES
This feature lets you record still images that
look like photographs onto a tape.
look like photographs onto a tape.
1
Set the VIDEO/MEMORY Switch to
“VIDEO”.
2
Set the Power Switch to “REC”.
3
Set the recording mode to “
M
”.
4
Set “REC SELECT” to
“
/
” or
“
5
Set “SNAP/SLOW” to “SNAP”. (
6
Press SNAPSHOT.
●
The
“PHOTO
” indication appears and a still image
will be recorded for approx. 5 seconds, then the
camcorder re-enters the Record-Standby mode.
camcorder re-enters the Record-Standby mode.
●
You can perform Snapshot also during
recording. A still image will be recorded for
approx. 5 seconds, then the normal recording
resumes.
recording. A still image will be recorded for
approx. 5 seconds, then the normal recording
resumes.
●
Snapshot is effective when the recording mode
selection is set to both
selection is set to both
“
A
”
or
“
M
”.
●
If the image taken by snapshot is too dark or too
bright, select
bright, select
pg. 39) or “SPOTLIGHT”
Motor Drive Mode
Keeping SNAPSHOT pressed in step
provides an effect similar to serial photography.
(Interval between still images: approx. 1
second)
(Interval between still images: approx. 1
second)
●
The Motor Drive mode is disabled when “REC
SELECT” is set to “
SELECT” is set to “
/
” or “
“.
The camcorder’s Full Range AF system offers
continuous shooting ability from close-up (as
close as approx. 5 cm (2") to the subject) to
infinity.
However, correct focus may not be obtained
depending on the shooting condition. In this
case, use the manual focus mode.
continuous shooting ability from close-up (as
close as approx. 5 cm (2") to the subject) to
infinity.
However, correct focus may not be obtained
depending on the shooting condition. In this
case, use the manual focus mode.
1
Set the Power Switch to “REC”.
2
Set the recording mode to “
M
”.
3
Press FOCUS. The manual focus indicator
appears.
4
Press
1
or
2
to focus on a subject.
●
When the focus level cannot be adjusted any
further or closer, “
further or closer, “
” or “
” will blink.
5
Press SET. Focus adjustment is complete.
To reset to Auto Focus
Press FOCUS twice.
Press FOCUS twice.
Manual focus is recommended in
situations listed below.
situations listed below.
●
When two subjects overlap in the same scene.
●
When illumination is low.*
●
When the subject has no contrast (difference in
brightness and darkness), such as a flat, one-
color wall, or a clear, blue sky.*
brightness and darkness), such as a flat, one-
color wall, or a clear, blue sky.*
●
When a dark object is barely visible in the LCD
monitor or the viewfinder.*
monitor or the viewfinder.*
●
When the scene contains minute patterns or
identical patterns that are regularly repeated.
identical patterns that are regularly repeated.
●
When the scene is affected by sunbeams or
light reflecting off the surface of a body of water.
light reflecting off the surface of a body of water.
●
When shooting a scene with a high-contrast
background.
background.
* The following low-contrast warnings appear
blinking: , ,
and .
Snapshot (Record Still Image On
Tape)
Tape)
Manual Focus
Manual focus indicator
2
2
2
2
1
1
1
1
SET
FOCUS
GR-D790US.book Page 37 Tuesday, November 7, 2006 1:39 PM