JVC GR-DVL522 Manual Do Utilizador

 EN

  

Make sure all units are turned off. Connect this

camcorder to a video unit equipped with a DV output
connector using a DV cable as shown in the
illustration.

Set this camcorder’s VIDEO/MEMORY Switch to

“VIDEO”, then the Power Switch to “PLAY” while
pressing down the Lock Button located on the switch.
Turn on the video unit’s power and insert the
appropriate cassettes in this camcorder and the video
unit.

Set  “REC MODE” to “SP” or “LP” in the Menu

Screen depending on your preference (

墌

 pg. 48).

Press the Recording Start/Stop Button on this

camcorder to engage the Record-Pause mode.
“

” appears on the screen.

Engage the video unit’s Play mode, then engage

the Still Playback mode when you have found a spot
just before the edit-in point.

Press the Recording Start/Stop Button on this

camcorder to engage the Record mode. 

 rotates

on the screen. Engage the video unit’s Play mode.

To stop dubbing, press the Recording Star/Stop

Button on this camcorder so that 

 stops rotating,

then engage the video unit’s Stop mode.

Repeat steps 5 through 7 for additional editing.

●

墌

●

If the remote control is used when both the player and recorder are JVC video units, both units will perform the same
operation. To prevent this from happening, press the buttons on both units.

●

If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an
unusual image is not dubbed.

●

Even though the DV cable is connected correctly, sometimes the image may not appear in step 5. If this occurs, turn
off the power and make connections again.

●

●

Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND
MODE” setting (

墌

 pg. 45).

●

During Digital Dubbing, no signals are output from the video or audio connectors.