Kenwood TM-D700E Manual Do Utilizador

12

q

q

q

q

q COM connector

Accepts a DB-9 female connector for connecting to a
computer.  See the separate manual, “SPECIALIZED
COMMUNICATIONS” {page 2}.

w

w

w

w

w

Accepts a 2.5 mm (1/10") 3-conductor plug for
connecting to a GPS receiver.  See the separate manual,
“SPECIALIZED COMMUNICATIONS” {page 10}.

e

e

e

e

e DATA connector

Accepts a 6-pin mini DIN plug for connecting to an
external TNC or an optional VC-H1.  See the separate
manual, “SPECIALIZED COMMUNICATIONS” {pages 2
and 35}.

r

r

r

r

r PANEL connector

Insert one end of the supplied modular plug cable for
connecting the front panel {page 4}.

t

t

t

t

t MIC connector

Insert the modular plug on the microphone cable until
the locking tab clicks {page 8}.

y

y

y

y

y RESET button

Press for 1 second or longer to perform Full Reset
{page 41}.  No confirmation message appears.  Use
this switch when the microcomputer and/or the
memory chip malfunction because of ambient factors.

Note:  With the transceiver power ON, do not connect cables to or
remove from the front panel of the main unit.

q

q

q

q

q Antenna connector

Connect an external antenna {page 7}.  When making
test transmissions, connect a dummy load in place of
the antenna.  The antenna system or load should
have an impedance of 50 

Ω

.  The TM-D700E accepts

a male N-type connector and other versions accept a
male PL-259 connector.  This transceiver has only
one antenna connector because of a built-in duplexer.

w

w

w

w

w Power Input 13.8 V DC cable

Connect a 13.8 V DC power source.  Use the
supplied DC power cable {pages 5 and 6}.

e

e

e

e

e Speaker jacks

If you wish, connect an optional external speaker for
clearer audio.  These jacks accept a 3.5 mm (1/8")
mono (2-conductor) plug.  See page 8.