Canon XC-10 Manual Do Utilizador

109

Playback

Playing an HD-sized Clip from a 4K Clip

When playing back a 4K clip, you can select an HD-sized portion of the frame to play back.
Output from the HDMI OUT terminal will be HD during this playback mode.

1 Play back the desired 4K clip.

2 During playback or playback pause, touch the screen to display the playback controls and then

touch [

• The screen will be magnified and a white frame representing the whole screen area is displayed on the top

left of the screen. The white rectangle within it represents the approximate part of the image being
displayed.

• Drag your finger across the screen to move the white rectangle around and select the portion of the image

to play back.

• Touch [

] to switch back to normal playback mode.

Capturing Photos from 4K Clips (4K Frame Grab) and HD Clips

You can capture a photo from a clip during playback pause. Captured photos are saved on the SD card. The
size of the photo will depend on the type of clip it was captured from.

1 Play back the clip from which you want to capture the photo.

2 Pause the playback at the point you want to capture (A 103).

• If you press the PHOTO button halfway during playback, the playback speed will slow to 1/8 normal,

allowing you to find the desired point more easily.

3 Press the PHOTO button or touch [

] to capture a photo.

• {Ð8 appears on the bottom right of the screen.

• The ACCESS indicator will flash as the photo is being recorded.

4 Touch [Ñ] to stop playback.

Photo size by clip type

IMPORTANT

• Observe the following precautions while the ACCESS indicator is on or flashing in red. Failure to do so may

result in permanent data loss.
- Do not disconnect the power source or turn off the camcorder.
- Do not open the recording media slot cover.

Operating modes:

Clip

Photo size

4K clip (4K Frame Grab)

3840x2160

HD clip

1920x1080

HD clip recorded in slow motion at x1/4

1280x720