Canon MD 216 Manual Do Utilizador

61

During playback there is video noise.

- Video heads are dirty. Clean the video heads (

Playback does not start.

- Load a cassette (

- Set the camcorder to 

 (

- Tape reached the end (“

END” appears on the screen). Rewind the tape (

No sound from the built-in speaker.

- Open the LCD panel.
- Speaker volume is turned off. Adjust the volume with the [SPEAKER VOLUME] setting (

Image will not appear on the TV screen.

- Check again that the camcorder is properly connected to the TV (

Tape is running, but image will not appear on the TV screen.

- TV/VIDEO selector on the TV is not set to VIDEO. Set the selector to VIDEO (

- Video heads are dirty. Clean the video heads (

- You attempted to play back or dub a copyright protected tape. Stop playback/dubbing.

(in alphabetical order)

CHANGE THE BATTERY PACK

- Battery pack is exhausted. Replace or charge the battery pack (

 

CHECK THE CASSETTE   [AUDIO MODE]

- You attempted to dub audio (

 49) on a tape recorded with an audio mode other than [

12bit].

 

CHECK THE CASSETTE   [BLANK]

- You attempted to dub audio (

 49) on a tape with a blank section.

 

CHECK THE CASSETTE   [INCORRECT TAPE SPECIFICATION]

- You attempted to dub audio (

 49) on a tape recorded in HD (high definition) standard.

 

CHECK THE CASSETTE   [REC MODE]

- You attempted to dub audio (

 49) on a tape recorded in a recording mode other than SP.

CONDENSATION HAS BEEN DETECTED

- Condensation has been detected in the camcorder (

CONDENSATION HAS BEEN DETECTED   REMOVE THE CASSETTE

- Condensation has been detected in the camcorder (

 66). Remove the cassette.

HEADS DIRTY, USE CLEANING CASSETTE

- Video heads are dirty. Clean the video heads (

CO

PY