Teledyne MODEL T703 Manual Do Utilizador

For network or Internet communication with the analyzer, connect an Ethernet cable from the analyzer’s rear 
panel Ethernet interface connector to an Ethernet port. Please refer to Section 7.5 for a description of the default 
configuration and setup instructions. 

For direct communication between the analyzer and a personal computer (PC), connect a USB cable between 
the analyzer and desktop or laptop USB ports. (If this option is installed, the COM2 port can only be used for 
RS232 multidrop communication; RS-485 communication cannot be enabled). The baud rate of the PC and the 
analyzer must match. See Section 7.1.3. 

If the instrument has this option, refer to Section 7.3 for setup and configuration. 

 

The Model T703 can be used as a Primary Ozone Standard.  For this application the performance of the T703 
Photometric Calibrator calibrated to Standard Reference Photometer (SRP)  

Calibrators ordered with this option are verified and validated in accordance with the procedures prescribed by 
the U.S. Environmental Protection Agency (EPA) under Title 40 of the Code of Federal Regulations, Part 50, 
Appendix D (40 CFR Part 50). 

An NIST traceable Certificate of Calibration and accompanies the instrument. 

07223B DCN6378