Teledyne MODEL T703 Manual Do Utilizador
Operating the T703 Calibrator
Teledyne API T703 Calibrator Operation Manual
60
6.5.1.2. Naming a Sequence
The first step of creating a calibration sequence is to assign it a name. The name can be up to 10 characters
and can be comprised of any alpha character (A to Z), and numeral (0 to 9) or the underscore character (“_“).
and can be comprised of any alpha character (A to Z), and numeral (0 to 9) or the underscore character (“_“).
To assign a name to a sequence, press,
SETUP X.X NAME:[0]
<CH
CH>
INS
DEL
[0]
ENTER EXIT
EXIT discards the
new NAME
ENTR accepts the
new NAME
Toggle to cycle through
the range of numerals
and available characters:
(“A – Z”; “0 – 9” & “ _ ”)
Moves the
cursor one
character left or
right.
Deletes a
character at the
cursor location.
Inserts a new a
character at the
cursor location.
STANDBY ACT CAL=0.000 LPM
<TST
TST>
GEN STBY SEQ
SETUP
Make sure that the
calibrator is in standby
mode.
SETUP X.X
PRIMARY SETUP MENU
GAS
SEQ
CFG
CLK PASS
MORE
EXIT
SETUP X.X
SEQUENCE CONFIGURATION
EDIT
PRINT
EXIT
SETUP X.X
END OF SEQUENCES
INS
PRNT
EXIT
SETUP X.X
1) SEQ [NAME], [X] STEPS
PREV NEXT
INS
DEL EDIT
PRNT
EXIT
SETUP X.X NAME:0
SET>
EDIT
EXIT
Deletes the sequence shown
in the message field
Edits the sequence shown
in the message field
Scrolls back and forth between
existing sequences
This display only appears if there are no sequences currently
programmed into the calibrator.
OTHERWISE ...
07223B DCN6378