Panasonic AG-HMC152EN Manual Do Utilizador
22
The remote control
Insert the battery
1
Push the catch in the direction shown by
arrow ① to remove the holder.
arrow ① to remove the holder.
2
Insert the battery with the “+” marked side
facing up.
3
Return the holder to its original position.
When the battery (CR2025) has run out, replace
it with a new one. (The battery lasts about one
year, depending on the frequency of use.)
it with a new one. (The battery lasts about one
year, depending on the frequency of use.)
If the remote control unit fails to work even when
it is operated near the camera-recorder’s remote
control sensor, the battery has run out.
Keep the battery out of the reach of children.
control sensor, the battery has run out.
Keep the battery out of the reach of children.
•
•
Remote control usable range
The distance between the remote control and the
unit’s remote control sensor: Within approx. 5 m
Angle: Approximately 10° upward,
unit’s remote control sensor: Within approx. 5 m
Angle: Approximately 10° upward,
approximately 15° downward,
approximately 15° leftward, or
approximately 15° rightward
(when the accessory battery is used)
approximately 15° leftward, or
approximately 15° rightward
(when the accessory battery is used)
Remote control
sensor (Rear)
sensor (Rear)
Remote control
sensor (Front)
sensor (Front)
The remote control is intended for indoor operation.
Outdoors or under strong light, the unit may not
operate properly even within the usable ranges.
Outdoors or under strong light, the unit may not
operate properly even within the usable ranges.
•
Turn on/off the camera
While pressing the lock release button, move the
POWER switch to ON or OFF.
POWER switch to ON or OFF.
Turn on the camera:
The mode lamp (CAM) lights red (CAMERA mode)
and the camera is now in the recording pause mode.
The mode lamp (CAM) lights red (CAMERA mode)
and the camera is now in the recording pause mode.
Turn off the camera:
The mode lamp (CAM) goes out.
The mode lamp (CAM) goes out.
Energy-saving mode
According to the settings made in the POWER
SAVE item of the OTHER FUNCTIONS screen
in the settings menu, the following will apply if
no designated operations∗ are performed for
approximately five minutes while recording is paused
(when an SD Memory Card has been inserted).
in the settings menu, the following will apply if
no designated operations∗ are performed for
approximately five minutes while recording is paused
(when an SD Memory Card has been inserted).
ON:
The camera recorder turns off automatically.
OFF:
Does not switch OFF the camera.
∗
See the setup menus, POWER SAVE
(Page 99) for details.
(Page 99) for details.
•
Mode lamp
STAND BY
MODE
CAM
PB
PC
Mode button
Lock release button
POWER
ON
OFF