Panasonic AG-HPG20P Manual Do Utilizador
1
Menu
RECORDING SETUP screen (continued)
Item
Description of settings
INT SG
This is used to set the type of built-in signal. In SD mode, SMPTE signal and ARIB
signal are set to BLACK.
100%CB: 100% color bar
5%CB: 75% color bar
SMPTE: SMPTE color bar
ARIB: ARIB color bar
BLACK: black
5M REC CH
This is used to set the number of audio channels for recording in DVCPRO (25M) or
DV compressed recording format.
CH:
Record in 2-channel.
CH:
Record in 4-channel.
<Note>
When 1394 input signal is selected, the same number of audio channel as that of
audio channel of 1394 input signal at the start of recording is recorded regardless of
setting made as above.
LOOP REC
This is used to select whether to perform LOOP REC or not.
ON:
Perform LOOP REC.
OFF:
Not perform LOOP REC.
<Note>
This is set to OFF when the power is turned on again.
AUTO REC
This is used to select whether to perform AUTO REC/STOP according to the
recording/stop signal of HD-SDI input signal sent from the camera recorder.
OFF:
Not perform AUTO REC/STOP.
TYPE1:
Perform AUTO REC/STOP according to the Recording Mark in LTC information
added to HD-SDI.
TYPE:
Perform AUTO REC/STOP according to the Recording Mark in SVITC information
added to HD-SDI.
TYPE:
This is selected when non-Panasonic camera recorders are used.
<Note>
When selecting TYPE1 or TYPE2, refer to “Panasonic camera recorder, recording
format and Recording Mark” (Page 92).
The devices supporting TYPE3 are Sony Corporation’s HDW-F900R and PDW-700.
(Confirmed in November, 2008)
•
•
The underlined settings are the factory mode settings.
HDW-F900R and PDW-700 are registered trademarks of Sony Corporation.