Panasonic AW-PB506AL Manual Do Utilizador

- 4 (E) -

   Two signal outputs for SDI signals 

compliant with the EBU Tech.67-E 
standard (BBC No. PSF1/M, BELDEN 
881 or equivalent coaxial cable; max. 
00 m)

   EDH (Error Detection and Handling) 

flags complying with the SMPTE RP165 
standard can be added.  
( A switch can be used to enable or 

disable the addition of these flags.)

   An inter-communications headset can be 

used and its volume adjusted.

   The STANDBY/ON switch function of 

the viewfinder (WV-VF65B, AW-VF80) is 
incorporated.

   Output signals (brightness and 

composite video signals) to the 
viewfinder can be switched using the 
menu settings.

   Zebra pattern and safety zone displays 

appearing in the viewfinder can be 
switched using the menu settings.

   The VIDEO ON/OFF switch function of 

the viewfinder (AW-VF64) is incorporated. 
( In order to prevent CRT burn-in, the 

AW-VF64 does not come with a standby 
function.)

Installing the SDI card in a convertible 
camera (such as the AW-E50, AW-E650,  
AW-E655, AW-E750 and AW-E860) and 
mounting the camera on the interface 
bracket makes it possible for a viewfinder 
and/or inter-communications headset to 
be used and thus enable the camera to 
be used as a studio camera. In addition, 
there are two signal outputs for SDI signals  
compliant with EBU Tech.67-E standard.

   The AW-PB506A cannot be installed 

to the following models;  
AW-E00, AW-E00A, AW-E00S, 
AW-E600, AW-E800, AW-E800A, 
AW-RP605, AW-PB605

   When the SDI card unit is to be 

discarded at the end of its service 
life, ask a specialized contractor 
to dispose of it properly in order to 
protect the environment.

   When connecting or disconnecting a 

cable from any unit, ensure that the 
power to that unit is turned off.

   Do not drop this product or subject it to 

strong shock or vibration, as this may 
cause it to malfunction.

   Avoid using the unit in very humid or 

dusty locations, as this may cause it to 
malfunction.

   Avoid using the product at a cold place 

below –10°C or at a hot place above 
+45°C because extremely low or high 
temperature will adversely affect the 
parts inside.