Hitachi JU-1000 Manual Do Utilizador
- 22 -
Example PC screen display:
C:
\Documents and Settings\Administrator>arp -a
Interface: 192.168.0.99 --- 0x2
Internet Address Physical Address Type
172.16.0.11 00-20-4a-95-18-84 static
7) Execute the Telnet command (1)
Try to access the IP address by the Telnet command with the port number "1".
NOTICE: Be sure to use the port number "1" although port number is typically used as
Telnet. It is the proper action for the next step although the telnet connection will fail.
Telnet. It is the proper action for the next step although the telnet connection will fail.
Command: telnet <IP address> <PortNumber>
Example PC screen display:
C:
\Documents and Settings\Administrator>telnet 172.16.0.11 1
8) Execute the Telnet command (2)
Next, access desired IP address by the telnet command with port number "9999".
NOTICE: When the command is correctly entered, the message "Press Enter for Setup
Mode" appears.
Mode" appears.
Press the "ENTER" key within 5 seconds to avoid the timeout of this prompt. When the
command is accepted, the following example screen is displayed on the PC.
command is accepted, the following example screen is displayed on the PC.
*You can check current IP address.
*In case of time-out, start from 7) again.
Command : telnet <IP address> <PortNumber>
Example PC screen display:
C:
\Documents and Settings\Administrator>
C:
\Documents and Settings\Administrator>telnet 172.16.0.11
9999
MAC address 00204A951884
Software version V6.1.0.0 (051122) XPTEXE
Press Enter for Setup Mode