Panasonic AG-HPX371E Manual Do Utilizador

164

Chapter

9

Maintenance

and
Inspections

HDD 
(USB 
HOST 
MODE)

CANNOT ACCESS 
CARD!

An error occurred during P2 card access. 

Check P2 card. 

CANNOT ACCESS 
TARGET!

An error occurred during hard disk access.  Check hard disk status and connection. 

CANNOT FORMAT!

The hard disk cannot be initialized. 

Connect another hard disk drive. 

CANNOT RECOGNIZE 
HDD!

The destination target cannot be properly 
recognized. 

Reboot the hard disk or connect a different 
hard disk. 

CARD IS EMPTY! 
CANNOT COPY!

The P2 selected for copying is empty. 

Copying is not performed since the card 
is empty. 

HDD CAPACITY FULL! Not enough space left on the hard disk. 

There is not enough space on the 
connected hard disk. Use a new hard disk 
or formatted hard disk. 

HDD DISCONNECTED! The unit is not connected to a hard disk. 

Reconnect the USB cable. If the hard disk 
does not operate normally, turn it off and 
turn it back on again. 

MISMATCH 
COMPONENT!

Copying cannot be made because the 
destination card is in the wrong format. 

Use a P2 card with the same model 
number or import video in clip units.

P2 CARD IS 
UNFORMATTED!

The P2 card is not formatted. 

Use a formatted P2 card. 

PLEASE FORMAT P2 
CARD!

This warning indicates that data could not 
be imported from a hard disk to a P2 card 
because the P2 card contained recorded 
data. 

You cannot copy to a P2 card that 
contains data. Format the card on a P2 
device and copy again. 

TOO MANY 
PARTITIONS!

There are too many partitions. 

Hard disks can handle up to 23 partitions. 
Use a new hard disk or formatted hard 
disk. 

TOO MANY TARGETS! Multiple devices are connected. 

Disconnect devices, turn off the unit and 
turn it back on again. 

UNKNOWN DEVICE 
CONNECTED!

The connected DVD drive is not compatible. 

Disconnect devices, turn off the unit and 
turn it back on again. 

VERIFICATION FAILED! The compare check after copying failed. 

Copy the data again.