Panasonic AG-HSC1UP Manual Do Utilizador

VQT1F36

ª Install a button-type battery

Install the supplied button-type battery in the 
remote control before using it.

While pressing the stopper A, 
pull out the battery holder.

Set the button-type battery with 
its (i) mark facing upward and 
then put the battery holder back 
in place.

≥When the button-type battery runs down, 

replace it with a new battery (part number: 
CR2025). The battery should normally last 
about 1 year, however this depends on how 
frequently the unit is used.

≥Keep the button-type battery out of the reach of 

children.

ª Remote control usable range

The distance between the remote control and the 
unit’s remote control sensor A: Within approx. 
5 m  (16 feet)
Angle: Approx. 10o up and 15o down, left, and 
right

≥The remote control is intended for indoor 

operation. Outdoors or under strong light, the 
unit may not operate properly even within the 
usable ranges.

Danger of explosion if battery is incorrectly 
replaced. Replace only with the same or 
equivalent type recommended by the 
manufacturer. Dispose of used batteries 
according to the manufacturer’s instructions.

Replace battery with Panasonic PART NO. 
CR2025 only. Use of another battery may 
present a risk of fire or explosion.
Caution: Battery may explode if mistreated.
Dispose of used battery promptly. Keep away 
from children. 
Do not recharge, disassemble or dispose of in 
fire.

A

A

VQT1F36_ENG_PP.book  25 ページ  ２００７年２月２６日　月曜日　午前１１時２９分