Sony F35 Manual Do Utilizador
112
Using the MSU-900/950
A
ppe
ndix
e
s
Settings on the MSU-900/950
Set the unit to Engineer mode and set the communication
parameters, using the Ethernet Configuration menu.
parameters, using the Ethernet Configuration menu.
For details on operations, refer to the Operation Manual of
the MSU-900/950.
the MSU-900/950.
Notes on LAN connection
• For stable operations of the connected devices, use the
system in a local network, without connecting to the
Internet.
Internet.
• Do not connect any device to the local network other
than the system units for this camera.
Recommended remote control devices for
which operation tests have been made
which operation tests have been made
Sony made
• MSU-900/950
• RM-B750
• MSU-900/950
• RM-B750
Equipment from other vendors
HUB CentreCOM FS909M-PS
HUB CentreCOM FS909M-PS
Menu
Item
Setting in Bridge mode
Setting in Multi mode
Master unit
Subordinate unit(s)
Connection
Mode selection
Bridge
MCS
Target IP SET
IP addresses of the connected
cameras
cameras
No setting required
Master IP SET
No setting required
IP address of the master
unit
unit
Master/Client
selection
selection
No setting required
Client
T
MSU No.
No setting required
1
2
Negotiation
Negotiation
AUTO or OFF
T
T
Speed
No setting required if Negotiation
is AUTO.
For the OFF setting, select 10M or
100M.
is AUTO.
For the OFF setting, select 10M or
100M.
T
T
Duplex
No setting required if Negotiation
is AUTO.
For the OFF setting, select HALF
or FULL.
is AUTO.
For the OFF setting, select HALF
or FULL.
T
T
IP Address
Setting
Setting
IP Address
IP address specific to the MSU
T
T
Net Mask
Value corresponding to the
network environments in use
network environments in use
T
T
Gateway
Address
Address
Value corresponding to the
network environments in use
network environments in use
T
T