Panasonic AW-HE130K Manual Do Utilizador
Digital Extender
Enable or disable the digital extender.
When this is set to [On], the digital zoom will be fixed at 1.4x.
When [Digital Zoom] is set to [Enable], [Digital Extender] is disabled.
Setting value:
Off
Disable the digital extender function.
On
Enable the digital extender function.
Tally
“Enable” or “Disable” is set here for the function which turns on or
turns off the tally lamp using the tally control signal.
Setting value:
Disable
Disable the tally lamp function.
Enable
Enable the tally lamp function.
Tally Brightness
Adjust the brightness of the tally LED.
Setting value:
Low
Low brightness
Mid
Medium brightness
High
High brightness
<NOTE>
• When this is set to [Low], the LED brightness is equivalent to that of
the AW-HE120.
OSD Mix
Select whether to turn off/on camera menu, status, and other displays
for each output image.
Setting value:
Off / On
SDI Out
HDMI Out
Video Out
IP
When this is set to [On], the camera menu, status, and other displays
for corresponding output image are displayed.
Setting value:
Off / On
<NOTE>
• When this is set to [Off], the camera menu can be displayed for
about 1 minute after the unit is turned on.
OSD Off With Tally
Enable or disable the function that turns off camera menu, status,
and other displays when tally signals are received via commands or
contacts.
When the tally signal releases, the camera menu display will return.
Setting value:
Off / On
OSD Status
Turn the status display during AWB and ABB on/off.
Setting value:
Off / On
Model Select
Set the protocol model for standard serial communication.
Do not select [Reserved1] to [Reserved7].
Appears when the service switch (SW4) at the bottom of the unit is
set to ON (standard serial communication).
Setting value:
SEVIHD1 / SBRC300 / SBRCZ330 / Reserved1 to 7
Multi-Screen setup screen
The cameras whose images are to be displayed on the multi screen are
set here. (→page@@, page @@)
IP address
Input here the IP address of the camera whose images are to be
displayed on the multi screen or the host name. With one group
consisting of 4 cameras, up to four groups of cameras (a total of 16
cameras) can be registered.
Input as follows if the HTTP port number of the camera whose images
are to be displayed has been changed.
IPv4 address entry
example
http://192.168.0.10:8080
IPv6 address entry
example
http://[2001:db8:0:0:0:0:0:1]:8080
Enter the following when connecting via HTTPS.
Example of
input
https://192.168.0.10/
Maximum
number of
characters
1 to 128 half-size characters
Factory settings:
Cam 1: selfcamera
Cam 2 to Cam 16: Not registered
<NOTE>
• When connecting via HTTPS, install the security certificate for the
camera to be displayed. (→page @@)
• This unit is configured for cameras for which “selfcamera” is
displayed for the IP address or host name.
• When configuring a host name, the DNS settings of the computer
that will display the multi screen must be configured. For details on
the computer’s DNS settings, consult your network administrator.
86
Web screen configurations (continued)
87