Panasonic BL-WV10 Manual Do Utilizador
Getting Started
20
Note
•
If the camera’s color night view mode is turned on, the image refresh rate and
overall image quality may decrease. As a result, objects may not be displayed
properly. In low-light environments, images may be out of focus when using the
pan/tilt feature or when the subject is moving. We recommend brightening the
subject or disabling color night view mode.
overall image quality may decrease. As a result, objects may not be displayed
properly. In low-light environments, images may be out of focus when using the
pan/tilt feature or when the subject is moving. We recommend brightening the
subject or disabling color night view mode.
1.5.1
If the Camera Image Does Not Appear
If the image from a camera that you registered using the Quick Setup utility does
not appear, confirm that the camera is turned on and that the Ethernet cable is
connected to the camera correctly. If the camera is a wireless camera with a
wired/wireless switch, such as the BL-C30, and is being used in wired mode, make
sure the camera’s switch is set to WIRED. If the camera is an HCM series wireless
camera being used in wired mode, make sure the Ethernet cable is connected to
the camera at the time the camera is turned on.
If the camera is a wireless camera with a wired/wireless switch and is being used
in wireless mode, make sure the camera’s switch is set to WIRELESS. If the
camera is an HCM series wireless camera being used in wireless mode, make sure
there is no Ethernet cable connected to the camera at the time the camera is
turned on. If the wireless signal from a wireless camera is too weak, motion images
may become disrupted. Confirm the strength of the signal by pressing DISPLAY
while viewing the camera.
Refer to the information on page 4 and relocate the camera if the signal is too
weak.
not appear, confirm that the camera is turned on and that the Ethernet cable is
connected to the camera correctly. If the camera is a wireless camera with a
wired/wireless switch, such as the BL-C30, and is being used in wired mode, make
sure the camera’s switch is set to WIRED. If the camera is an HCM series wireless
camera being used in wired mode, make sure the Ethernet cable is connected to
the camera at the time the camera is turned on.
If the camera is a wireless camera with a wired/wireless switch and is being used
in wireless mode, make sure the camera’s switch is set to WIRELESS. If the
camera is an HCM series wireless camera being used in wireless mode, make sure
there is no Ethernet cable connected to the camera at the time the camera is
turned on. If the wireless signal from a wireless camera is too weak, motion images
may become disrupted. Confirm the strength of the signal by pressing DISPLAY
while viewing the camera.
Refer to the information on page 4 and relocate the camera if the signal is too
weak.
No signal
Poor signal
Weak signal
Strong signal
BL-WV10_GS-en.book Page 20 Wednesday, January 25, 2006 5:18 PM