Panasonic BL-WV10 Manual Do Utilizador

Getting Started

24

Incorrect security code. 
(ED1)

This error is displayed if the security code entered to 
display the [General Setup] or [Camera Setup] 
screens is incorrect.

•

Enter the correct security code. If you’ve 
forgotten it, press the FACTORY DEFAULT 
RESET button to reset the BL-WV10 and 
re-register all cameras using Quick Setup.

Cannot connect to 
camera. (ED2)

This error is displayed when the camera cannot be 
accessed.

•

Check the camera’s power and connections 
and its IP address as displayed in the camera 
settings.

•

If using wireless cameras, refer to the wireless 
communications information on page 4.

Cannot communicate with 
the camera. (ED3)

This error is displayed when the camera cannot be 
accessed.

•

Check the camera’s power and connections 
and its IP address as displayed in the camera 
settings.

•

If using wireless cameras, refer to the wireless 
communications information on page 4.

Settings could not be 
saved. (ED4)

This error is displayed if a camera’s access is lost 
when changing local camera settings.

•

Check the camera’s power and connections 
and its IP address as displayed in the camera 
settings.

This error can also be displayed if unusable 
characters were used to register a camera name for 
preset registration or local camera settings.

•

Register using appropriate characters.

Enter a name for the 
Preset. (ED5)

This error is displayed if, during preset registration, 
the registered name field is left blank.

•

Enter a preset registered name.

The timer could not be set 
because the recording 
start and end time are the 
same. Set a different start 
or end time. (ED6)

This error is displayed if the start and end times for 
timer recording are the same.

•

There must be a difference of at least one 
minute between start and end times.

BL-WV10_GS-en.book  Page 24  Wednesday, January 25, 2006  5:18 PM