Bosch ICP-CC404 Manual Do Utilizador
ICP-CC404 | Installation Guide | 20.0 Terminals and Descriptions
80 Bosch
Security
Systems,
Inc. | 12/08 | F01U089401-02
Table 65:
(continued)
Term
Description
master code
A numeric code used for arming and disarming the system, and for allowing access to
all functions available through the codepad.
all functions available through the codepad.
monitoring station
A secure location where a digital receiver monitors a number of alarm systems and
deciphers their alarm transmission reports so the operator can advise the appropriate
authorities to take immediate action.
deciphers their alarm transmission reports so the operator can advise the appropriate
authorities to take immediate action.
panic
A condition or type of alarm in which the user requires either immediate police or
medical assistance.
medical assistance.
phone controller
A device used to arm a security system over the telephone line, and to acknowledge
domestic alarm reports.
domestic alarm reports.
remote radio user
code
code
A code used to arm and disarm a system from a remote location, using hand-held
transmitters (in AWAY Mode or STAY Mode 1). Remote panic alarms are also allowed.
transmitters (in AWAY Mode or STAY Mode 1). Remote panic alarms are also allowed.
sealed
Refers to a zone’s status. If a zone is sealed, the detection devices are not violated and
the zone indicator is not lit (that is, a reed switch is closed or a detector is on standby
waiting for an intrusion).
the zone indicator is not lit (that is, a reed switch is closed or a detector is on standby
waiting for an intrusion).
sensor watch
A feature that allows the control panel to recognize when detection devices might have
stopped working. Sensor watch monitors the operation of a zone over a programmed
time period.
stopped working. Sensor watch monitors the operation of a zone over a programmed
time period.
silent alarm
An alarm that sounds only at a remote location, and gives no obvious local indication
that an alarm was sent out.
that an alarm was sent out.
STAY Mode 1
A condition that automatically isolates certain zones when the security system is armed
in this mode. Only the installer can program these zones.
in this mode. Only the installer can program these zones.
STAY Mode 2
A condition that automatically isolates certain zones when the security system is armed
in this mode. The Master Code holder can program these zones.
in this mode. The Master Code holder can program these zones.
telco arming
sequence
sequence
A feature that automatically diverts a telephone number to another telephone when a
security system is armed in AWAY Mode, the same as using call forwarding.
security system is armed in AWAY Mode, the same as using call forwarding.
telco disarming
sequence
sequence
An automatic suspension of diverting of the telephone when the system is disarmed.
unsealed
Refers to a zone’s status. If a zone is unsealed, the detection devices are violated and
the zone indicator is lit (that is, a reed switch is open or a detector noted an intrusion).
the zone indicator is lit (that is, a reed switch is open or a detector noted an intrusion).
user code
A numeric code used to arm and disarm the system.
zone
A monitored input used to activate an alarm. A zone might be set up to activate an
alarm only when the system is armed or to operate whether the system is armed or
disarmed.
alarm only when the system is armed or to operate whether the system is armed or
disarmed.