Canon FDW75C12N Manual Do Utilizador

3.  Mount the housing assembly to the mounting bracket 

and housing coupling.  A safety cable is included with 
the housing to temporarily hold it while making wiring 
connections.  Loop the safety cable over one of the set 
screws on the housing coupling  and make the appropriate 
connections using the (2) screw-down connectors supplied.

4.  Undo the safety cable and twist the housing onto the 

housing coupling.  Secure all (3) setscrews provided on the 
housing coupling.

Set screws

1.  Choose the desired location for installation and mark 

the drill holes using the template. Screw (2) bolts (not 
provided) about ¾ of the way into the (2) top holes. Run 
approximately 8 of wiring out of the wall.

NOTE:  Be sure the hardware and the mounting surface 

2.  The wall mount bracket provided with the FDW7 includes 

a location for conduit entry. If you wish to install conduit to 
the bracket remove the conduit hole plug. Install fitting from 
below the wall mount and secure with conduit nut from 
inside the bracket.

3.  Open the access door on the bottom of the wall mount by 

loosening the screw nearest the mounting plate.

4.  Attach the wires from the wall to the connector provided. 

using the wiring color code chart as a guide.

5.  Once all wiring connections are made, place the wires 

inside the wall mount bracket and close the access door. 
Secure with the screw removed earlier.

Access panel

1.  Open the access door on the bottom of the wall mount by 

loosening the screw nearest the mounting plate.

2.  There is a safety lanyard that is attached to the inside of 

the dome assembly.  Take the open end of the lanyard and 
loop it around the lanyard tab that is located inside the 
housing top.

3.  The safety lanyard is now attached to the housing.