Desa CB36N Manual Do Utilizador
www.desatech.com
117437-01D
8
TROUBLESHOOTING
Continued
POSSIBLE CAUSE
1..Turning. gas. control. knob.
to.HI.position.when.burner.
is.cold
is.cold
..Air.in.gas.line
3..Dirty. or. partially. clogged.
burner orifice
1..Flame. impingement. on.
logs
..Debris. around. burner. air.
mixer
1..Metal. expanding. while.
heating. or. contracting.
while.cooling
while.cooling
1..Battery.is.not.installed.or.
battery.is.power.is.low
1..High.or.gusting.winds
..Low.line.pressure
3..Pilot.is.partially.clogged
4..Improper.or.restricted.vent-
ing
5. Clogged burner tube,
blocked orifice or improper
burner air adjustment
burner air adjustment
6..Bad.thermopile.or.thermo-
couple
7..Vent. cap. improperly. in-
stalled.or.blocked
OBSERVED PROBLEM
Heat. produces. a. whistling.
noise.when.burner.is.lit
noise.when.burner.is.lit
Glass.soots
Fireplace.produces.a.clicking/
ticking noise just after burners
are.lit.or.shut.off
ticking noise just after burners
are.lit.or.shut.off
Remote.does.not.function
Fireplace.shuts.off.in.use.
Burner backfiring during com-
bustion
Burner backfiring during com-
bustion
REMEDY
1..Turn.gas.control.knob.to.LO.
position.and.let.warm.up.for.
a.minute
a.minute
..Operate. burner. until. air. is.
removed. from. line.. Have.
gas.line.checked.by.pro.
pane/LP. or. natural. gas.
company
gas.line.checked.by.pro.
pane/LP. or. natural. gas.
company
3..Clean.burner.(see.Cleaning
and Maintenance, page 24)
or replace burner orifice
or replace burner orifice
1. Adjust the log set so the
flame does equipment shut-
off.valve
off.valve
..Inspect.the.opening.at.the.
base. of. the. burner. to. see.
that. it. is. not. packed. with.
any.type.of.material
that. it. is. not. packed. with.
any.type.of.material
1..This. is. normal.. If. noise. is.
excessive, contact qualified
service.person
service.person
1..Replace. 9-volt. batteries. in.
receiver.and.remote.control
1..Fireplace.has.been.tested.for.
up. to. 40. mph. winds.. How-
ever, extreme conditions
may. occur.. See. Lighting
Instructions, page 20 or 21
ever, extreme conditions
may. occur.. See. Lighting
Instructions, page 20 or 21
..Check.local.propane/LP.or.
natural.gas.company
3..Clean. pilot. (see. Cleaning
and Maintenance, page
4)
4)
4..Locate.and.correct.all.vent.
conditions.(see.Checking for
Proper Venting, page 10)
Proper Venting, page 10)
5..Clean. burner. tube. and.
orifice, adjust air shutter
(see. Inspecting Burners,
page.3)
(see. Inspecting Burners,
page.3)
6..Replace. faulty. compo-
nents
7..Check. for. proper. installa-
tion. or. remove. debris. or.
blockage
blockage