Enerco MHVFR30LPT Manual Do Utilizador

Installation Instructions and Owner’s Manual

Unvented LP-Gas Vent Free Room Heaters

1.  Drill holes at marked locations using 5/16” drill 

bit. For solid walls (concrete or masonry), drill 

at least 1” deep.

2.  Fold wall anchor as shown in figure 8 below.

3.  Insert wall anchor (wings first) into hole. Tap 

anchor flush to wall.

4.  For thin walls (1/2” or less) insert red key into 

wall anchor. 

5.  Place mounting bracket onto wall. Line up 

holes on each end of bracket with wall anchors.

6.  Insert mounting screws through bracket and 

into wall anchors.

7.  Tighten screws until mounting bracket is firmly 

fastened to wall.

Placing Heater on Mounting Bracket

1.  Locate two horizontal slots on back pane of 

heater (see figure 9).

2.  Place heater onto mounting bracket. Slide hori-

zontal slots onto stand-out tabs on mounting 

bracket.

Installing Bottom Mounting Screws

1.  Locate two bottom mounting holes. These 

holes are near bottom on back panel of heater 

(see figure 10).

2.  Mark screws locations on wall.
3.  Remove heater from mounting bracket.

4.  If installing bottom mounting screw into hollow 

or solid wall, install wall anchors. Follow steps 1 

through 4 under Attaching to Wall using Anchor. 

If installing bottom mounting screw into wall 

stud, drill holes at marked locations using 9/64” 

drill bit.

5.  Re-place heater onto mounting bracket.
6.  Place spacers between bottom mounting holes 

and wall anchor or drilled hole.

7.  Hold spacer in place with one hand. With the 

other hand, insert mounting screw through 

bottom mounting hole and spacer. Place tip of 

screw in opening of wall anchor or drilled hole.

8.  Tighten both screws until heater is firmly se-

cured to wall. Do not over tighten.

Note: Do not re-place front panel at this time. Re-

place front panel after making gas connections and 

checking for leaks.

Installing Support Feet (see figure 11)

1.  Lay heater onto table on its back with bottom 

edge overhanging table edge.

2.  Securely attach feet to bottom of heater using 

2 – self-tapping screws each.

Note: Feet should have long end going out the 

front of heater, and the edge coinciding with side of 

heater. If feet overhang side of the heater, switch 

leg location.
3.  Place heater on non-combustible surface (see 

Locating Heater above) before proceeding with 

gas connection. If this will be a permanent loca-

tion, heater may be locked into position using 

anchoring holes in mounting feet.

Note: Use of floor mounting feet will require you to 

use a 3/8 NPT street elbow to make gas connection.

WARNING: A qualified service person must con-

nect heater to gas supply. Follow all local codes. 

Screw  

hole

Screw  

hole