FMI CCL3924PTA/NTA Manual Do Utilizador

www.fmiproducts.com

124971-01C

19

5. Turn control knob counterclockwise

to the PILOT position. Press in

control knob for five (5) seconds (see

Figure 31).

Note: You may be running this heater

for the first time after hooking up to gas

supply. If so, the control knob may need

to be pressed in for 30 seconds or more.

This will allow air to bleed from the gas

system.
• If control knob does not pop out when

released, contact a qualified service

person or gas supplier for repairs.

6. With control knob pressed in, press and

release ignitor button. This will light pilot.

The pilot is attached to the front burner. If

needed, keep pressing ignitor button until

pilot lights.

Note: If pilot does not stay lit, contact a

qualified service person or gas supplier

for repairs. Until repairs are made, light

pilot with match. To light pilot with match,

see Manual Lighting Procedure.

7. Keep control knob pressed in for 30 sec-

onds after lighting pilot. After 30 seconds,

release control knob.

Note: If pilot goes out, repeat steps 3

through 7. This heater has a safety inter-

lock system. Wait one (1) minute for sys-

tem to reset before lighting pilot again.

8. Turn control knob counterclockwise

to desired heating level. The burn-

ers should light. Set control knob to any

heat level between HI and LO.

9. Turn control knob clockwise

to the

PILOT position to shut off burner leaving

pilot lit.

TO TURN OFF GAS

TO APPLIANCE

1. Turn control knob clockwise

to the

OFF position.

2. Close equipment shutoff valve (see Figure

16, page 15).

THERMOSTAT

CONTROL OPERATION

The thermostat control knob can be set to any

comfort level between HI and LO. The ther-

mostat will gradually modulate the heat output

and flame height from higher to lower settings

or pilot, in order to maintain the comfort level

you select. The ideal comfort setting will vary

by household depending upon the amount of

space to be heated, the output of the central

heating system, etc.
Note: Selecting the HI setting with the control

knob will cause the burners to remain fully on,

without modulating down in most cases.

MANUAL LIGHTING

PROCEDURE

1. Follow steps 1 through 5 under Lighting

Instructions, page 21.

2. Press control knob and light pilot with

match.

3. Keep control knob pressed in for 30 sec-

onds after lighting pilot. After 30 seconds,

release control knob. Now follow step 8,

under Lighting Instructions, column 1.

Figure 24 - Control Knob and Ignitor

Button Location

Figure 25 - Pilot

LO

HI

OFF

Pilot

Control Knob

Ignitor Button

Thermocouple

Pilot Burner

Ignitor

Electrode

OPERATION

Continued

THERMOSTAT-CONTROLLED MODELS