FMI CCL3924PTA/NTA Manual Do Utilizador

124971-01C

4

1.  This appliance is only for use with the type 

of gas indicated on the rating plate. This 

appliance is not convertible for use with 

other gases.

2.  Do not place propane/LP supply tank(s) 

inside any structure. Locate propane/LP 

supply tank(s) outdoors (propane/LP units 

only).

3.  To  prevent  performance  problems,  do 

not use propane/LP fuel tank of less than 

100 lb. capacity (propane/LP units only).

4.  If you smell gas

• shut off gas supply

• do not try to light any appliance

• do not touch any electrical switch; do not 

use any phone in your building

• immediately call your gas supplier from 

a neighbor’s phone. Follow the gas sup-

plier’s instructions

• if you cannot reach your gas supplier, 

call the fire department

5.  This gas log set may not be installed 

as a vented appliance in a bedroom or 

bathroom.

6.  Before installing in a solid fuel burning fire-

place, the chimney flue and firebox must 

be cleaned of soot, creosote, ashes and 

loose paint by a qualified chimney cleaner. 

Creosote will ignite if highly heated. A dirty 

chimney  flue  may  create  and  distribute 

soot  within  the  house.  Inspect  chimney 

flue for damage. If damaged, repair flue 

and firebox before operating heater.

7.  Do not burn solid-fuel in a masonry or 

UL127  factory-built  fireplace  in  which  a 

vent-free room heater is installed.

8.  If fireplace has glass doors, never operate 

this heater with glass doors closed. If you 

operate  heater  with  doors  closed,  heat 

buildup inside fireplace will cause glass to 

burst. Make sure there are no obstructions 

across openings of fireplace.

9.  This log heater is designed to be smoke-

less. If logs ever appear to smoke, turn off 

heater and call a qualified service person. 

heater burning manufacturing residues. 

10. To prevent the creation of soot, follow the 

instructions in Cleaning and Maintenance, 

page 20.

11. Before using furniture polish, wax, carpet 

cleaner or similar products, turn heater off. If 

heated, the vapors from these products may 

create a white powder residue within burner 

box or on adjacent walls or furniture.

12. This heater needs fresh, outside air ven-

tilation to run properly. This heater has an 

Oxygen Depletion Sensing (ODS) safety 

shutoff system. The ODS shuts down the 

heater if not enough fresh air is available. 

See Air for Combustion and Ventilation, 

page 6. If heater keeps shutting off, see 

Troubleshooting, page 22.

13. Do not run heater

• where flammable liquids or vapors are 

used or stored

• under dusty conditions

14. Do not use this heater to cook food or burn 

paper or other objects.

15. Do not use heater if any part has been ex-

posed to or under water. Immediately call 

a qualified service technician to inspect 

the room heater and to replace any part 

of the control system and any gas control 

which has been under water.

16. Do not operate heater if any log is broken. 

Do not operate heater if a log is chipped 

(dime-sized or larger). 

17. Turn heater off and let cool before servic-

ing. Only a qualified service person should 

service and repair heater.

18. Operating heater above elevations of 

4,500 feet could cause pilot outage.

19. Provide adequate clearances around air 

openings.