DeLonghi RFH9030 Manual Do Utilizador
ELECTRICAL CONNECTION
-
-
Before using the appliance check that your supply voltage is the same of that shown on the
rating label of the unit.
rating label of the unit.
INSTALLATION
The appliance can be used as a portable unit only, resting on any horizontal surface.
The appliance must not be positioned directly underneath a fixed power point.
The appliance can be used as a portable unit only, resting on any horizontal surface.
The appliance must not be positioned directly underneath a fixed power point.
OPERATION
-
-
Summer use
(ventilation only): turn the mode selector clockwise to the position. The indicator light
switches on.
-
Heating at low power
: turn the mode selector to the 1 position.
-
Heating at maximum power
: turn the mode selector to the 2 position.
-
Setting the mode selector
: when the room temperature has reached the desired level, slowly turn the
mode selector counter-clockwise until the indicator light goes out but no further. The appliance will now
automatically maintain the temperature at the desired level.
automatically maintain the temperature at the desired level.
-
Anti-freeze function
With the mode selector in the thermostat position , the appliance maintains the room of about 5
degrees C (41 degrees F) thus preventing freezing with minimal energy consumption.
With the mode selector in the thermostat position , the appliance maintains the room of about 5
degrees C (41 degrees F) thus preventing freezing with minimal energy consumption.
-
Switching the heater off:
turn the mode selector fully counter-clockwise to the “O” position.
To direct the air flow in the required direction, tilt the appliance manually to one of the two positions, 1
or 2 (see fig. 2/3).
or 2 (see fig. 2/3).
MAINTENANCE
- Always unplug the appliance before cleaning the heater.
- Periodically clean the air intake and outtake grille during the period in which the heater is
- Always unplug the appliance before cleaning the heater.
- Periodically clean the air intake and outtake grille during the period in which the heater is
in use.
- Do not use abrasive cleaning products or solvents.
CAUTION
- Do not use this heater in the immediate proximity of showers, bathrubs, swimming pools, etc.
- Always use the heater in an upright position.
- Do not use the heater to dry your laundry. Never obstruct the intake and outtake grilles (dan-
- Do not use this heater in the immediate proximity of showers, bathrubs, swimming pools, etc.
- Always use the heater in an upright position.
- Do not use the heater to dry your laundry. Never obstruct the intake and outtake grilles (dan-
ger of overheating).
- The heater must positioned at least 50 cm (20 inches) from furniture or other objects.
- Do not use the appliance close to walls, furniture, curtains etc.
- If the power cable is damaged, it must be replaced by the manufacturer, an authorized servi-
- Do not use the appliance close to walls, furniture, curtains etc.
- If the power cable is damaged, it must be replaced by the manufacturer, an authorized servi-
ce center or a qualified electrician in order to eliminate all risk.
- Do not cover the appliance when in operation as this could cause a fire risk.
- Do not use the appliance in rooms less than 4 m
- Do not use the appliance in rooms less than 4 m
2
(43 square feet).
The heater is fitted with a safety thermal cut-off which will switch off the heater in case of acci-
dental overheating
dental overheating
(eg. obstruction of air intake and outtake grilles, motor turning slowly or not
at all). To reset, turn the heater off, disconnect the plug from the outlet for a few minutes, remove
the cause of overheating then plug the appliance in again.
Warning:
the cause of overheating then plug the appliance in again.
Warning:
in order to avoid overheating, do not cover the heater.
4