Ives 7226/26F Folheto

Improper pivot set installation can lead to personal injury or property damage. Follow

all instructions carefully. For questions contact Technical Support at 1-888-371-7331.

1. Prepare and mortise top of door and head jamb to receive pivot set. Determine pivot location

using dimensions on reverse side. The pivots are non-handed. To determine hand of door
and proper pivot position, see diagrams above.

2. Locate, drill, and tap 1/4-20 mounting holes for metal door or metal frame. Locate and drill

pilot holes for #14 wood screws for wood door or wood frame. Install pivot leafs with 1/4-20 x 3/4”
FHMS or #14 FHWS screws provided.

3. Loosen set screw in pin leaf with 3/32” Allen wrench provided and remove pivot pin.

4. Use 5/32” Allen wrench to remove pivot cap from door leaf, allowing for pivot pin re-insertion.

5. With door in open position (about 90° to jamb), carefully fit door onto bottom pivot at a slight

angle. Tip door into vertical position, aligning top pivot leafs in door and jamb. With pivot
leafs aligned, insert pivot pin into pivot set. Vertically align groove in pivot pin with set
screw in pivot leaf. Tighten set screw securely with 3/32” Allen wrench. Re-install pivot cap.

6. To remove door from jamb: Remove pivot cap. Thread a 1/4-20 machine screw into end of

pivot pin. Pull pivot pin out of pivots. Door can now be removed from opening.

Right hand

installation

Left hand

installation

Pin leaf

Bearing

leaf

Pivot

pin

Pivot cap

5/32” Allen wrench

Bearing leaf

Set screw

3/32” Allen wrench

Pin leaf

1/4-20 tapped hole for

pin removal (both ends)