Hunter Fan 42700 Manual Do Utilizador

42700-01 • 01/15/08 • Hunter Fan Company

All wiring must be in accordance with national and local electrical 
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a 
qualified electrician.
Wall switches are not included. Select an acceptable general-use switch
in accordance with national and local electrical codes.
7-1.  Disconnect the power by turning off the circuit breakers to the

outlet box and associated wall switch location.

7-2.  Place the receiver inside the canopy, making sure that the

dipswitches and the oval shaped holes in the bottom of the
receiver are facing down toward the bottom of the canopy.

7-3.  Spread the receiver lead wires to each side and feed the wires from

the top of the fan through the open slot in the receiver.

7-4.  Place the receiver in the canopy. Make sure the slot in the receiver

is aligned with the hook in the ceiling plate.

7-5.  To connect the wires, hold the bare metal leads together and

place a wire connector over them, then twist clockwise until tight.
Using the small wire connectors, connect the fan to the receiver as
follows:

• Connect the yellow wire from the fan to the yellow wire from

the receiver.

• Connect the pink wire from the fan to the pink wire from the

receiver.

• Connect the grey wire from the fan to the grey wire from the

receiver.

• Connect the red wire from the fan to the red wire from the

receiver.

• Connect the black wire with a white stripe from the fan to the

black wire with a white stripe from the receiver.

• Connect the white wire from the fan to the white wire  

(LIGHT OUT) from the receiver.

Large Wire 

connector

Small Wire 

connector