Hunter Fan 42503-01 Manual Do Utilizador

Página de 14
4
Hunter Fan Company 
42503-01 • 02/08/06
5
42503-01 • 02/08/06 
Hunter Fan Compan
 CAUTION: To avoid possible electrical shock, before installing your fan, 
disconnect the power by turning off the circuit breakers to the outlet box 
and associated wall switch location. If you cannot lock the circuit breakers 
in the off position, securely fasten a prominent warning device, such as a 
tag, to the service panel.
2-1.  Drill two pilot holes into the wood support structure through the 
outermost holes in the outlet box. e pilot holes should be 9/64” 
in diameter.
2-2.  Your fan comes with four neoprene noise isolators (“Isolators”). 
Position the isolators between the ceiling plate and ceiling by 
inserting the raised areas on each isolator into the holes in the 
ceiling plate.
2-3.  read the lead wires from the outlet box down through the hole 
in the middle of the ceiling plate.
2-4.  Align the slotted holes in the ceiling plate with the pilot holes you 
drilled in the wood support structure. For proper alignment use 
slotted holes directly across from each other. 
    Note: e isolators should be flush against the ceiling.
2-5.  Place a flat washer on each of the two 3” wood screws and pass 
the screws through the slotted holes in the ceiling plate into the 
pilot holes you drilled. 
    Tighten the screws into the 9/64” pilot holes; do not use lubricants 
on the screws. Do not over tighten.
Flat Washer
3” Wood 
Screw
2 • Installing the Ceiling Plate
Step 2-2
Steps 2-3 – 2-5
For Angled Ceilings: Be sure to 
orient the ceiling plate so that the 
arrows printed on the ceiling plate are 
pointing towards the ceiling peak. 
Ceiling
 Plate
Isolator