Hunter Fan 45041-01 Manual Do Utilizador

45041-01  •  09/30/09  •  Hunter Fan Company

You can assemble your fan for standard or angled mounting as shown 
in steps 3-1 – 3-3. For low profile mounting (ceilings less than 8 feet 
high), go to steps 3-6 – 3-9 on the next page. 
3-1.  To assemble fan to hang down from a flat or angled ceiling, place 

the canopy and canopy trim ring around the adapter so that they 
rest on the fan assembly. 

3-2.  Feed the wires from the fan through the downrod.
    Note: Make sure all the wires are on the same side of the metal 

dowel pin inside the dowrod.

3-3.  Loosen the square head setscrew on the adapter to install the pipe 

and ball assembly. Note: When the pipe and ball assembly is fully 
installed, 2-3 threads on the pipe will still be visible; this is normal. 
Securely retighten the setscrew with a wrench or pliers.

     

 CAUTION: The adapter has a special coating on the threads. Do 

not remove this coating; the coating prevents the downrod from 
unscrewing. Once assembled, do not remove the downrod.

     

 WARNING:  Do not carry or lift fan by canopy.

3-4.  Raise the fan and place the ball into the hanger bracket. 
3-5.  Align the notch on the ball with the indent in the hanger bracket. 

(Rotate the fan until you hear the notch pop into place.) 

    Go to 4 • Wiring the Fan.
     

 WARNING:  Fan may fall if not assembled as directed in these 

installation instructions.

Indent

Downrod

Canopy

 (with Washer)

Canopy 

Trim 

Ring

Setscrew

Adapter