Heath Zenith 598-1109-06 Manual Do Utilizador
This package includes (Style of push button and chime may vary from illustration):
• Wireless chime
• Wireless push button with battery
• Hardware pack
This chime requires 4 “C” alkaline batteries (not included). In typical use,
alkaline batteries will last up to 2
• Wireless chime
• Wireless push button with battery
• Hardware pack
This chime requires 4 “C” alkaline batteries (not included). In typical use,
alkaline batteries will last up to 2
1
/
2
years.
Wireless Mechanical
Battery Operated
Chime
© 2008 HeathCo LLC
598-1109-06
Figure 2
Figure 3
1. Install alkaline type A23 12 volt push button
battery (included). Remove back of case by
pushing in tab on bottom with a small screw-
driver. See diagram inside push button for
correct battery orientation. Note: If batteries
are preinstalled, remove orange battery tab.
pushing in tab on bottom with a small screw-
driver. See diagram inside push button for
correct battery orientation. Note: If batteries
are preinstalled, remove orange battery tab.
2. Remove chime cover. Pull firmly as shown
in Figure 2.
3. Install 4 alkaline “C” batteries in chime.
Make sure batteries are oriented properly as
shown in Figure 3.
shown in Figure 3.
4. Test range. Temporarily position chime and
push button where you want them mounted.
Press push button to verify chime and push
button work properly. If chime does not sound,
see Troubleshooting.
Press push button to verify chime and push
button work properly. If chime does not sound,
see Troubleshooting.
Figure 1
1 2 3 4 5 6 7
ON
Type
“C”
Type
“C”
Ty
pe
“C”
Ty
pe
“C”
WARNING: To prevent possible
SERIOUS INJURY or DEATH:
• NEVER allow small children near
batteries.
• If battery is swallowed, immediately
notify doctor.