Empire Products FAW-55IP Manual Do Utilizador

OFF

No “Call for Heat”

Not applicable

None

Flash Fast

Startup-Flame sense calibration

Not applicable

None

Heart Beat

Normal operation

Not applicable

None

3

Recycle

  - Flame failed during run

Initiate new trial for ignition. Flash code 

will  remain  through  the  ignition  trial 

until flame is proved.

If system fails to light on next trial for 

ignition, check gas supply, pilot burner, 

flame  sense  wiring,  contamination  of 

flame rod, burner ground connection.

4

Flame sensed out of sequence

If situation self corrects within 10 sec-

onds, control returns to normal sequence. 

If flame out of sequence remains longer 

than 10 seconds, control goes to Flash 

code 6 + 4 (see below).

Check for pilot flame. Replace gas valve 

if pilot flame present. If no pilot flame, 

cycle  “Call  for  Heat.”  If  error  repeats, 

replace control.

7

Flame sense leakage to ground

Control  remains  in  wait  mode.  When 

the fault corrects, control resumes nor-

mal operation after a one minute delay.

Check flame sense lead wire for damage 

or shorting. Check that flame rod is in 

proper position.

Check  flame  rod  ceramic  for  cracks, 

damage or tracking.

8

Low  secondary  voltage  supply  -  

below 15.5 Vac)

Control  remains  in  wait  mode.  When 

the fault corrects, control resumes nor-

mal operation after a one minute delay.

Check transformer and AC line for proper 

input voltage to the control. Check with 

full system load on the transformer.

6 + 2

Failed trial for ignition resulting 

in lockout

Remain in lockout until “Call for Heat” 

is cycled.

Check  gas  supply,  pilot  burner,  spark 

and flame sense wiring, flame rod con-

taminated  or  out  of  position,  burner 

ground connection.

6 + 3

More than 5 flame failures during 

run on the same “Call for Heat” 

resulting in lockout

Remain in lockout until “Call for Heat” 

is cycled.

Check  gas  supply,  pilot  burner,  flame 

sense  wiring,  contamination  of  flame 

rod, burner ground connection.

6 + 4

Flame  sensed  out  of  sequence  -  

longer than 10 seconds

Control  waits  until  flame  is  no  longer 

sensed  and  then  goes  to  soft  lockout. 

Flash code continues. Control auto re-

sets from soft lockout after one hour.

Check for pilot flame. Replace gas valve 

if pilot flame present. If no pilot flame, 

cycle  “Call  for  Heat.”  If  error  repeats, 

replace control.

ON

Soft lockout due to error detected 

during self check sequences

Control auto resets from soft lockout af-

ter one hour.

Reset by cycling “Call for Heat.” If er-

ror repeats, replace the control.

a

Flash Code Descriptions:

  -  Flash Fast: Rapid blinking

  -   Heartbeat: Constant 1/2 second bright 1/2 second dim cycles

  -  A single flash code number signifies that the LED flashes X times at 2Hz, remains off for two seconds, 

and then repeats the sequence.

  -  X + Y flash codes signify that the LED flashes X times at 2Hz, remains off for two seconds, flashes Y 

times at 2Hz, remains off for three seconds, and then repeats the sequence.

12429-10-0408

Page 15