Louisville Tin and Stove W255F Manual Do Utilizador

B-W VENT

FIGURE 3

Casing

“Z Bracket
Front Panel

Front
Panel

Door

FIGURE 5C

To place furnace into position, grasp

furnace and lift so furnace flue vent and header
plate vent opening engage.  Do not use burner or
gas control to lift heater.  Lift furnace upward and
swing bottom into wall opening until legs rest on
floor plate and are flush to finished wall.  For proper
combustion, level heater front to back and side to
side.  Nail legs to studs.  DO NOT BEND LEGS
as this will put the entire unit into a bind and cause
expansion noises (See Figure 3).

STEP 7.

A drip leg and a manual valve equipped

with a 1/8 N.P.T. plugged tapping accessible for
test gauge connection should be installed
immediately upstream of the gas supply connection
to the appliance.  Some codes and ordinances
require that the manual valve be located outside
the appliance.

STEP 8.

Make gas connection using connector the

same size as gas connection of furnace.  CHECK
ALL CONNECTIONS FOR GAS LEAKS
WITH LEAK DETECTOR SOLUTION.  DO
NOT USE OPEN FLAME.

For wall thermostat units, see “Wiring”

section for thermostat connections.  Make sure
all connections are correct and connector stems
are not touching.

 To fasten front panel to furnace, be sure

exposed portion of header is free of debris.  Place
outer panel over furnace with top of panel about
one inch above header and centered in opening.
Keep front panel flush to finished wall and slide
down until rear flange of top outer panel is wedged
tight against the front of the plaster ground channel
and flush with wall.  CAUTION:  Do not hang
front panel behind (over front lip) the plaster
ground channel as this could result in
excessive noise.  Open bottom door of front
panel and place sheet metal screw into locking
latch.  Secure top of front panel to header plate
with screw provided.  This will hold front panel
securely to wall.  See Figures 5A, 5B, (See Page
8), and 5C (Page 9).

Page 9

BURNER
SHELF

FIGURE 4