Petsafe LDT-433 Manual Do Utilizador
6
www.petsafe.net
Prepare the Receiver Collar
Your Receiver Collar comes with short Contact Points installed. Use the long Contact
Points for pets with long or thick hair. Tighten the Contact Points with pliers one-half
turn beyond fi nger tight (2A). Check the tightness weekly.
Points for pets with long or thick hair. Tighten the Contact Points with pliers one-half
turn beyond fi nger tight (2A). Check the tightness weekly.
To Insert and Remove the Batteries
1. Remove the screws with a small Phillips screwdriver (2B).
2. For the LDT-433 only, push the Battery Lid up according
2. For the LDT-433 only, push the Battery Lid up according
to the arrows stamped on the Battery Lid (2B).
3. Slide the Battery Lid out.
4. Install two (2), 3-volt batteries positive (+) side up (2C, 2E).
5. Slide the Battery Lid into the Receiver Collar.
6. Reinstall the screws (2C, 2F). Do not over-tighten the screws.
4. Install two (2), 3-volt batteries positive (+) side up (2C, 2E).
5. Slide the Battery Lid into the Receiver Collar.
6. Reinstall the screws (2C, 2F). Do not over-tighten the screws.
Replacement batteries (3-volt, CR2032) can be found at
many retailers. Contact the Customer Care Centre or visit our
website at www.petsafe.net for a list of common retailers.
many retailers. Contact the Customer Care Centre or visit our
website at www.petsafe.net for a list of common retailers.
3
3
2
A-67
4
1
2
5
2A
TO R
EMO
VE
SLID
E TH
EN L
IFT
TO R
EMO
VE
SLID
E TH
EN L
IFT
2B (LDT-433)
Batteries
(CR2032)
2C (LDT-433)
Receiver Collar
Batteries
(CR2032)
Waterproof
Seal
2D (BDT-433)
2E (BDT-433)
2F (BDT-433)
Step
2