GTO 352 Manual Do Utilizador

42      

 

 

 

M i g h t y   M u l e   3 5 2

A.   

The simplest solution is to install the opener in a push-to-open configuration (requires Push-To-

Open Bracket, see Accessory Catalog).  The minimum clearance is easier to achieve and clearance 

is no longer a problem, since the opener will be pushing the gate away from the column instead of 

pulling it toward the column.  It is recommended that you place a steel plate between the opener 

mounting brackets and masonry surface for additional strength.

B.   

If a push-to-open installation is impossible due to traffic hazards, terrain, etc., another option is 

to re-hang the gate.  You may hang it on a post, either in the center of the column or at the back 

corner, or move the gate to the back corner of the columns.

C.   

The most difficult solution is to cut a notch in the column to accommodate the opener and power 

cable.  This job is 

NOT for the inexperienced!

A

Column Mount Example 
(A + B can not exceed 14 inches)
Example:  If A is 2" then B can not exceed 12"