Regency P40-NG Manual Do Utilizador

Regency

®

 P40 Direct Vent Gas Fireplace

INST

ALLA

TION

1)  Unwrap the Brick Panels from the protective wrapping.

3)  Place the 2 small Back Brick Panels at the base of the fi rebox on 

the left and right side of the burner assembly.

 Note: Ensure that the full brick pattern is on the bottom and the half 

brick pattern is on top to line up (approximately) with grout lines on 
side brick panels.

4)  Insert the Back Brick Panel by slipping it between the back wall of 

the fi rebox and the burner assembly, sitting it on the small back brick 
panels installed in step 3.

5)  Remove the Top Brick Panel Bracket by removing the 3 screws.

6)  Place the Top Brick Panel over the back brick panel and secure with 

the top brick panel bracket.

7)  Remove the screw on the left side of the fi rebox. Place the left side 

brick panel in position and secure using the brick tab and screw. 
Repeat for right side brick panel.

Must install 1 set of brick panels with the P40.