Regency P40-NG Manual Do Utilizador

Regency

®

 P40 Direct Vent Gas Fireplace

OPERA

TION

1)  Read and understand these instructions 

before operating this appliance.

2)  Check to see that all wiring is correct and 

enclosed to prevent possible shock.

3)  Check to ensure there are no gas leaks.

4)  Make sure the glass in the door frame is 

properly positioned. Never operate the 
appliance with the glass removed.

5)  Verify that the venting and cap are 

unobstructed.

6)  Ensure that the brick panels are installed.

7)  Verify log placement. If the pilot cannot be 

seen when lighting the unit, the logs have 
been incorrectly positioned.

8)  The unit should never be turned off, and on 

again without a minimum of a 60 second 
wait.

1)  Push in gas control knob slightly and turn 

clockwise to “OFF”. Knob cannot be turned 
from “PILOT” to “OFF” unless knob is pushed 
in slightly.  Do not force.

2)  Wait fi ve (5) minutes  to clear out any gas. 

3)  Turn knob  on gas control counterclockwise        

to “PILOT”.

4)  Push in control knob all the way and hold  in 

until the pilot lights up. Continue to hold the 
control knob in for about 20 seconds after 
the pilot is lit. Release knob and it will pop 
back up. Pilot should remain lit. If it goes out, 
repeat steps 1) to 4).  If knob does not pop 
up when released, stop and immediately 
call your service technician or gas supplier. 
If the pilot will not stay lit after several tries, 
turn the gas control knob to “OFF” and call 
your service technician or gas supplier.

5)  Turn gas control knob counterclock-wise to 

“ON”.

6)  Turn the unit on. 

 

NOTE: If using the remote control refer to 
the FireWizard manual for instructions.

1)  Press the ON/OFF switch once.

2) The 

LED 

will 

fl 

ash.

3)  Turn the main gas control clockwise to the 

"OFF" position to turn off the pilot.

4)  Turn off all electric power to appliance if 

service is to be performed.

Only when the pilot holds, without pressure 
being applied to the control knob, reapply the 
tension springs to the door. The unit must 
not be operated with the tension springs 
unattached. 

The  FIRST FIRE in your heater is part of the 
paint curing process. To ensure that the paint 
is properly cured, it is recommended that you 
burn your fi replace for at least four (4) hours the 
fi rst time you use it with the fan on. 

When fi rst operated, the unit will release an 
odour caused by the curing of the paint and the 
burning off of any oils remaining from manufac-
turing. Smoke detectors in the house may go off 
at this time. Open a few windows to ventilate 
the room for a couple of hours. The glass may 
require cleaning.

NOTE:  The main burner will always start on 

"HIGH" and resume it's last setting after 
20 seconds of operation.

NOTE: When the glass is cold and the appliance 

is lit, it may cause condensation and fog 
the glass. This condensation is normal 
and will disappear in a few minutes as 
the glass heats up.

DO NOT ATTEMPT TO CLEAN THE 
GLASS WHILE IT IS STILL HOT!